Emerson CF230ORB00, CF230WW00, CF230BS00 owner manual Installation of Battery

Remote Control Procedures (cont.)

Installation of Battery

1.Remove the battery cover by pressing firmly below the arrow and sliding the cover off the control (Figure 27).

2.Install two AAA alkaline batteries and reinstall the battery cover.

REMOTE CONTROL

LEVERS

1 2 3 4 5

TWO AAA

BATTERIES

	CODE
	SWITCHES
BATTERY	REMOTE CONTROL
COMPARTMENT
COVER

Figure 27

Installation of Storage Bracket for Remote Control

A storage bracket is provided for holding your remote control when not in use. If you desire to use the bracket, install it on a wall that is away from excess heat or humidity (Figure 28).

TO INSTALL BRACKET TO WALL:

SLIDE THE COVER UP TO EXPOSE THE SCREW HOLES FOR INSTALLATION

COVER

WALL

BRACKET

SCREW

HOLES (2)

Figure 28

Setting Operating Frequency of Remote Control

Your remote control has code switches which must be set in one of 32 possible code combinations (Figure 29). The five levers (numbered 1, 2, 3, 4, and 5) on the switches are factory-set in the ON (up) position. Change the switch settings as follows (Figure 29):

1.Slide the five switch levers in the remote control to your choice of ON (up) or down positions. Use a ball-point pen or small screwdriver and slide the levers firmly up or down.

2.Restore electrical power to the ceiling fan at the circuit breaker panel or fuse box.

3.Within 1 minute of restoring electricity, push and

hold the remote control OFF button () for 3 to 5 seconds to set the code in the receiver. The fan's lights will blink several times to confirm the fan is programmed.

NOTE: The ceiling fan receiver will not respond to transmitter commands if the transmitter’s frequency switch settings are changed without reprogramming the receiver. Program the receiver to the new frequency by repeating the “Setting Operating Frequency of Remote Control” and “High Speed Conditioning” instructions.

15 U.L. Model No.: CF230