Emerson CF230WW00, CF230ORB00, CF230BS00 owner manual How to Assemble Your Ceiling Fan Standard

Installation of Blades & Light Assembly (continued)

5.Position the light kit plate assembly onto the fan motor assembly, careful to not pinch any wires during installation.

6.Rotate the light kit plate assembly counter- clockwise to engage the two key slots with the two screws in the fan motor assembly.

7.Reattached the screw (removed in Step 3) into the light kit plate assembly and securely tighten the three screws (Figure 8).

NOTE: Do not engage the light bulb at this time.

NOTE: Continue to Close-to-the-Ceiling instal- lation if needed.

Figure 8

REINSTALL FAN

MOTOR SCREW

RETIGHTEN TWO FAN

MOTOR SCREWS

How to Assemble Your Ceiling Fan (Standard)

Proceed to "Close-To-The-Ceiling" section on page 11 if you are not using the downrod to hang your ceiling fan.

NOTE: Carefully turn partially assembled ceiling fan over and place into the packing styrofoam to complete the assembly of your ceiling fan. Be extra careful with the blades while turning the fan over.

1.	Remove the hanger ball by loosening the setscrew in
	the hanger ball until the ball falls freely down the
	downrod (Figure 9). Remove the pin from the
	downrod, then remove the hanger ball. Retain the pin
	and hanger ball for reinstallation in Step 7.
2.	Loosen setscrew in motor coupler if necessary.
	Separate, untwist and unkink the three 80” motor

PIN

HANGER BALL

DOWNROD

SETSCREW

Figure 9

leads. Route the motor lead wires through the

downrod. Align the clevis pin holes in the downrod with

the holes in the motor coupler. Install the clevis pin and

secure with the hairpin clip (Figure 10). The clevis pin

must go through the holes in the motor coupler and the

holes in the downrod. Be sure to push the straight leg

of the hairpin clip through the hole near the end of the

clevis pin until the curved portion of the hairpin clip

snaps around the clevis pin. The hairpin clip must be

properly installed to prevent the clevis pin from working

loose. Pull on the downrod to make sure the clevis pin

is properly installed.

!WARNING

SETSCREW (2)

CLEVIS PIN

Figure 10

DOWNROD

HAIRPIN

CLIP

MOTOR COUPLING

It is critical that the clevis pin in the motor coupler is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.

3.While pulling up on the downrod, securely tighten the two setscrews in the motor coupling (Figure 11).

NOTE: The setscrews must be properly installed as described above, or fan wobble could result.

DOWNROD

MOTOR COUPLING

SETSCREW (2)

Figure 11

7 U.L. Model No.: CF230