Emerson CF230ORB00, CF230WW00, CF230BS00 owner manual Unpacking Instructions, Materials

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,

Install, Operate and Maintain Your Ceiling Fan

THIS FAN IS SUITABLE FOR DAMP LOCATIONS SUCH AS COVERED PORCHES, COVERED PATIOS,

AND COVERED DECKS...ANYWHERE THERE IS A ROOF OVERHEAD.

USE ONLY WITH LIGHT KITS MARKED SUITABLE FOR USE IN DAMP LOCATIONS.

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
One 1/4” blade screwdriver	One wire stripper

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

! WARNING

Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 9 or 12). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

! WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

! WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

1.Open carton containing fan. Remove top half of styrofoam unit. Remove parts and check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor assembly

b.One hanger bracket

c.One 4.5” downrod assembly

d.One ceiling cover trim ring

e.One ceiling cover with trim plugs

f.One lower cover

g.One light kit plate assembly

h.One coupler cover

i.Four fan blade flanges

j.Four fan blades

k.One 50 watt GU10 base light bulb

l.RCFP-190 receiver & SR400 transmitter

m.One loose parts bag containing:

1.Three 12 ga. wire connectors

2.Thirteen #10-24 x 5/16" flange head blade screws

3.Four #10-24 x 3/16" pan head screws

4.Four #10 external tooth lockwasher

5.One rubber gasket

6.One #8-32 x 5/16” light switch screw (spare)

7.One 1/4-20 x 9/16” flange screw with lockwasher (spare)

8.Two threaded stud, #8-32 x 1-1/4”

9.Two external tooth lockwashers

10.Two knurled knobs, #8-32

11.One clevis pin

12.One hairpin clip

13.One balancing kit

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

2.Remove the fan assembly from the protective plastic bag. Place the fan assembly into the upper foam pad with the lead wires up.

b.

a.

c.

d.

g.

e.

k.

h. f.

l. l.

i.

j.

m.

3 U.L. Model No.: CF230