Woodstock Mastering Roller Height Adjustments with the Rotacator

Page 34

W1754 20" Planer With Mobile Base

7.Adjust the height of the infeed roller on the same side as the Rotacator to the specification given at the beginning of this procedure, using the zero set- ting of the Rotacator as a reference point. Figure 30 shows the jam nut and set screw for adjusting the roller height.

8.Repeat Steps 6–7on the left-hand side of the infeed roller.

9.Double-check and micro-adjust both sides of the infeed roller, then carefully lock both sides in place.

10.Using the same zeroed reference on the Rotacator, adjust the height of the outfeed roller, pressure bar, and chip breaker to their given specifications. The adjustment controls for each are shown in Figures 30-32.

	Infeed
	Roller	OFF
	Roller
	Jam
	Nuts
Set	Set	Outfeed
Screw	Screw	Roller
Figure 30. Typical roller height
adjustment controls.

Adjustment
Location	OFF
	OFF

Pressure Bar

Bracket

Figure 31. Typical pressure bar height adjustment controls (One side shown. Bar not in sight.)

SERVICE

OFF

Adjustment

Location

Chip Breaker

Figure 32. Typical chip breaker height adjustment controls (One side shown).

-32-

Image 34

Contents Planer with Mobile Base Page Contents Introduction Woodstock Technical SupportIntroduction Controls and Features Safety Standard Safety InstructionsAlways Lock Mobile Bases Before Operating Machinery Additional Safety Instructions for Planers Electrical Electrical Specifications220V Operation Unpacking SetupItems Needed for Setup InventoryLifting Planer Machine PlacementHardware and Tools Not Shown Cleaning Machine These items are coated and must be cleanedExtension Wings Extension wing fasteners Leveling controlsTo install the caster and foot pedal, do these steps To install the handwheel, do these stepsHandwheel, Dust Hood Caster Gearbox Oil Level Connecting to PowerTo check the gearbox oil level, do these steps Test Run To perform a test run, do these stepsRecommended Adjustments Tighten V-BeltsBasic Operation OperationsGeneral Basic steps of operating the planer are as followsOperation Tips Feed Speed Feed control knob positionsTo adjust the bed rollers, do these steps Adjustment Height Range 002-0.020Bed Rollers Accessories Planer AccessoriesOperations Cleaning MaintenanceMaintenance Schedule Belts To adjust/replace the V-belts, do these stepsPulley Alignment on Lubrication Inspecting Knives ServiceTo inspect the knives, do these steps Setting/Replacing Knives To set the knives, do these stepsTo adjust the chain tension, do these steps Chain TensionTable Parallelism Maximum Allowable TolerancesTo adjust the table parallelism, do these steps Table micro-adjustment screwsRollers, Breaker Pressure Bar Heights Distance Below Knife Edge at *BDCLocation Service To adjust roller spring tension, do these steps Spring TensionLoosen the chip deflector mounting bolts see Figure Scale CalibrationTo calibrate the scale, do these steps Anti-Kickback Fingers Anti-kickback fingersPulley Alignment Example of checking belt AlignmentW1754 Electrical Components Motor junction boxW1754 20 Planer With Mobile Base Troubleshooting Problem Possible Cause Corrective ActionCutting Headstock Assembly Parts Breakdown Headstock Assembly Parts List PART# DescriptionCutterheadpulley Gearbox Parts Breakdown Gearbox Parts List Base Breakdown Base Parts List Table Breakdown & List Columns Breakdown Columns Parts List Labels & Cosmetic Parts Warranty Page Warranty Registration CommentsBOX BELLINGHAM, WA