Woodstock W1754 owner manual Extension Wings, Extension wing fasteners Leveling controls

Page 14

W1754 20" Planer With Mobile Base

Extension Wings

SET UP

Extension wings are heavy and could cause per- sonal injury if dropped during installation. Have an assistant hold the table while you fasten it to the planer.

To attach the table extension wings, do these steps:

1.Install the M8-1.25 x 20 set screws in the holes in the bottom of the wings (Figure 5).

2.With the help of an assistant, attach the table extension wings to the planer table (Figure 5) with the M8-1.25 x 35 hex bolts. Finger tighten the bolts for now.

3.Check table-to-extension wing alignment (Figure 6) with a straightedge and adjust the leveling set screws until the table and wings are flush.

4.Tighten the hex bolts.

-12-

Hex Bolts

Set Screws

Figure 5. Extension wing fasteners and

leveling controls.

Figure 6. Example of leveling extension

wings and table.

Image 14

Contents Planer with Mobile Base Page Contents Introduction Woodstock Technical SupportIntroduction Controls and Features Safety Standard Safety InstructionsAlways Lock Mobile Bases Before Operating Machinery Additional Safety Instructions for Planers 220V Operation Electrical SpecificationsElectrical Unpacking SetupItems Needed for Setup InventoryHardware and Tools Not Shown Machine PlacementLifting Planer Cleaning Machine These items are coated and must be cleanedExtension Wings Extension wing fasteners Leveling controlsHandwheel, Dust Hood Caster To install the handwheel, do these stepsTo install the caster and foot pedal, do these steps To check the gearbox oil level, do these steps Connecting to PowerGearbox Oil Level Test Run To perform a test run, do these stepsRecommended Adjustments Tighten V-BeltsBasic Operation OperationsGeneral Basic steps of operating the planer are as followsOperation Tips Feed Speed Feed control knob positionsBed Rollers Adjustment Height Range 002-0.020To adjust the bed rollers, do these steps Accessories Planer AccessoriesOperations Maintenance Schedule MaintenanceCleaning Pulley Alignment on To adjust/replace the V-belts, do these stepsBelts Lubrication To inspect the knives, do these steps ServiceInspecting Knives Setting/Replacing Knives To set the knives, do these stepsTo adjust the chain tension, do these steps Chain TensionTable Parallelism Maximum Allowable TolerancesTo adjust the table parallelism, do these steps Table micro-adjustment screwsRollers, Breaker Pressure Bar Heights Distance Below Knife Edge at *BDCLocation Service To adjust roller spring tension, do these steps Spring TensionTo calibrate the scale, do these steps Scale CalibrationLoosen the chip deflector mounting bolts see Figure Anti-Kickback Fingers Anti-kickback fingersPulley Alignment Example of checking belt AlignmentW1754 Electrical Components Motor junction boxW1754 20 Planer With Mobile Base Troubleshooting Problem Possible Cause Corrective ActionCutting Headstock Assembly Parts Breakdown Headstock Assembly Parts List PART# DescriptionCutterheadpulley Gearbox Parts Breakdown Gearbox Parts List Base Breakdown Base Parts List Table Breakdown & List Columns Breakdown Columns Parts List Labels & Cosmetic Parts Warranty Page Warranty Registration CommentsBOX BELLINGHAM, WA