Emerson Figure i manual Electrical data-Quiet-Line models 95F/35C 60Hz

Page 27

Installation

Table 18 Electrical data—Quiet-Line models (95°F/35°C) 60Hz

	Nominal			Input Voltage-Phase
	Capacity	* Electrical
	Capacity	* Electrical
Model #	Tons	Characteristic	208/230-1		208/230-3	460-3	575-3

		FLA	13.0		—	—	—

27	2	WSA	16.0		—	—	—

		OPD	25		—	—	—

		FLA	18.8		12.3	6.4	5.2

37	3	WSA	23.3		15.2	7.8	6.4

		OPD	40		25	15	15

		FLA	—		14.8	6.9	5.9

42	3.5	WSA	—		18.3	8.5	7.3

		OPD	—		30	15	15

		FLA	—		21.1	10.9	8.8

67	5	WSA	—		25.9	13.4	10.8

		OPD	—		45	20	15

*FLA = Full Load Amps

WSA = Wire Size Amps (minimum supply circuit current capacity) OPD = Overcurrent Protection Device (fuse or circuit breaker) Model # 14, 20 and 96 are not available in Quiet-Line versions.

Table 19 Electrical data—Standard sound and ambient models (95°F/35°C) 50Hz

	Nominal		Input Voltage-Phase
	Capacity	* Electrical
	Capacity	* Electrical
Model #	Tons	Characteristic	220-1	200/230-3	380/415-3

13	1	FLA	9.9	—		—

19	1.5	FLA	10.9	—		—

26	2	FLA	12.7	—		4.9

36	3	FLA	18.4	—		7.0

41	3.5	FLA	—	15.3		8.5

66	5	FLA	—	24.1		13.2

95	8	FLA	—	—		20.3

*FLA = Full Load Amps

Table 20 Electrical data—High ambient models (105°F/41°C) 50Hz

	Nominal		Input Voltage-Phase
	Capacity	* Electrical
	Capacity	* Electrical
Model #	Tons	Characteristic	220-1	200/230-3	380/415-3

13	1	FLA	—	—		—

19	1.5	FLA	—	—		—

26	2	FLA	14.8	—		6.0

36	3	FLA	20.5	—		13.1

41	3.5	FLA	—	19.8		9.6

66	5	FLA	—	24.2		13.2

95	8	FLA	—	—		—

*FLA = Full Load Amps

23

Image 27

Contents Liebert Prop Fan Condensing Unit = 380/415-3ph-50Hz Example PFH037A-PL7Table of Contents Figures Optional Equipment Prop Fan Condensing UnitsLocation Considerations Equipment InspectionCabinet and floor planning data, horizontal air discharge Dimensional DataNet Weight Model Numbers Dimensional Data, in. mm Lb. kg 60Hz 50HzFootprint Dimensions Wall Mounting Electrical and piping connections, horizontal air discharge Piping and Electrical ConnectionsPFH096A- L 152General piping arrangement Top Air Discharge Models Electrical field connections, 1- to 5-ton unitsElectrical field connections, 8-ton units Single-phase, 1-3 ton model schematic, typical Three-phase, 3-5 ton model schematic, typical Three-phase, 8 ton model schematic, typical Piping for Elevation Differences between PFH and Evaporator Piping ConsiderationsEvaporator Condensing UnitEquivalent lengths for various pipe fittings, ft m Line Size Length Charge R-407C Ft. m Lb-oz kg Pre-Charged Line SetsField-Fabricated Line Sets Refrigerant charge in Liebert pre-charged R-407C line setsRecommended line sizes, OD Cu Liebert PFH unit charge levels and coupling sizeLine Size OD Cu Coupling Size Torque, lb-ft. N-m Installation of Piping to UnitsPiping connection sizes and torque Line charges refrigerant per 100 ft m of Type L copper tubeFilter Drier Selection and Installation Install the New Condensing UnitRemove Existing Condensing Unit General System Charge Requirements Evaporator Charge LevelsEvaporator Charge R-407C Indoor Unit Models Oz kg Low-Voltage Control Wire Connections Low-Voltage Control Wire SizingElectrical Connections Electrical data-High ambient models 105F/41C 60Hz Nominal Input Voltage- Phase Capacity ElectricalNominal Input Voltage-Phase Capacity Electrical Electrical DataElectrical data-High ambient models 105F/41C 50Hz Electrical data-Quiet-Line models 95F/35C 60HzElectrical data Quiet-Line models 95F/35C 50Hz Checklist for Completed InstallationCompressor High Head PressureLiebert Lee-Temp Flood Back Head Pressure Control Adjustment Hot Gas BypassOperation Hot gas bypass diagram Mechanical Failure GeneralCompressor Failure Electrical Failure-BurnoutCompressor Replacement Field Charge Verification Field verification chargeModel Numbers 407C 60 Hz 50 Hz Oz kg Problem Cause Remedy TroubleshootingEtwo Single-Phase&Three-Phase UPS Environmental SystemsWeb Site Monitoring Uni