Emerson MRLDS operation manual FCC Compliance Notice

Page 3

Computer Process Controls, Inc.

1640 Airport Road Suite #104

Kennesaw, GA 31044

Phone 770-425-2724

Fax 770-425-9319

ALL RIGHTS RESERVED

The information contained in this manual has been carefully checked and is believed to be accurate. However, Computer Process Controls, Inc. assumes no responsibility for any inaccuracies that may be contained herein. In no event will Computer Process Controls, Inc. be liable for any direct, indirect, special, incidental, or consequential damages resulting from any defect or omission in this manual, even if advised of the possibility of such damages. In the interest of continued product development, Com- puter Process Controls, Inc. reserves the right to make improvements to this manual, and the products described herein, at any time without notice or obligation.

Computer Process Controls, Inc. products may be covered by one or more of the fol- lowing Computer Process Controls U.S. patents: 6360553, 6449968, 6378315, 6502409, 6779918, and Computer Process Controls Australian patent No. 775,199 No- vember 4, 2004.

FCC COMPLIANCE NOTICE

This device complies with Part 15 of the FCC Rules. Operation is subject to the fol- lowing two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Image 3
Contents Rev 1 Page FCC Compliance Notice Page Table Of Contents Page Specifications Powering The MrldsMrlds Models Mounting The Sensor Choosing a Mounting LocationMrlds Dimensions Mrlds WiringNetwork Layout Refrigerant Type J2J1 Refrigerant Jumper SettingsController Setup For Analog Mrlds 1 E2 Controllers Version 2.5 and NewerMrlds Network Addressing Mrlds SetupMrlds Wiring Rmcc ControllersMrlds Termination Address SettingsRefrigerant Jumper Settings Modbus Address J5J4J3 Jumper SettingsGateway Board Mrlds Gateway Setup on I/O NetworkMrlds Gateway Gateway ConnectionsThree-Board Six-Board Powering the Gateway BoardWire Connections Input VoltageGateway Board I/O Net Addressing Termination SettingsSelect Screen Setting the Baud Rate Dip SwitchesMrlds Setup Hand-Held Terminal Set TingsDesignating Mrlds as a 16AI Board Controller Setup for Modbus MrldsGateway Troubleshooting Mapping The Mrlds as an Irlds ApplicationPress 2 to Set Device #’s Reflecs Setup for Irlds IIs3 E2/Einstein Controllers Rmcc Controllers Version 2.1 and NewerSensor Setup Input DefinitionsSensor Setpoints Alarm Setpoints E2 AlarmingIrlds Mode 2 16AI Mode