SUPER MICRO Computer user manual Processors, Memory, SBI-7426T-S3 Blade Specification Features

SBI-7426T-S3 Blade Module User’s Manual

1-3 Blade Module Features

Table 1-1lists the main features of the SBI-7426T-S3 blade module. See the proceeding section for components typically included in a blade system and other optional components. Specific details on the SBI-7426T-S3 blade module is found in Chapter 4: " Blade Module Features" on page 4-1.

Table 1-1. SBI-7426T-S3 Blade Specification Features

Mainboard	B8DT6 (proprietary form factor)
	Chassis Dimensions (HxWxD): 11.32” x 1.67” x 18.9”
Processors	Single or dual Intel™ Xeon® 5500 Sequence processors. Please refer to
	our web site for a complete listing of supported processors.
FSB Speed	QPI speed, up to 6.4 GT/s bus speed
Chipset	Intel 5500 Tylersburg
Graphics Controller	Hermon
BIOS	32 MB SPI Flash EEPROM wiht AMI® BIOS
Memory Capacity	Twelve 240-pin DIMM sockets supporting up to 96 GB/24 GB of VLP ECC
	Registered/Unbuffered ECC DDR3-1333/1066/800SDRAM.
Drive Controller	LSI SAS2 on-board controller for three SAS2 or SATA disk drives
Hard Drive Bays	Three (3) hot-swap drive bays for 2.5" SAS2 or SATA disk drives

Processors

The SBI-7426T-S3 blade module supports up to dual 1366-pin Intel Xeon 5500 series processors.

Refer to the Supermicro web site for a complete listing of supported processors (http:// www.supermicro.com/products/superblade). Please note that you will need to check the detailed specifications of a particular blade module for a list of the CPUs it supports.

Details on installation of the processor into the SBI-7426T-S3 blade module are found in Chapter 3: "Setup and Installation" on page 3-1.

Memory

The SBI-7426T-S3 blade module has twelve 240-pin DIMM sockets that can support up to 96 GB/24 GB of VLP ECC Registered/Unbuffered ECC DDR3-1333/1066/800 SDRAM. Memory is interleaved, which requires modules of the same size and speed to be installed in groups (of two or three).

Please refer to the Supermicro web site for a list of supported memory

(www.supermicro.com/products/superblade). The detailed specifications for a blade module will contain a link to a list of recommended memory sizes and manufacturers.

Details on installation of memory modules into the SBI-7426T-S3 blade module are found in Chapter 3: "Setup and Installation" on page 3-1.

1-2