SBI-7426T-S3 Blade Module User’s Manual
Table A-1. BIOS POST Messages (Continued)
BIOS Message
Previous boot incomplete - Default configuration used
Memory Size found by POST differed from CMOS
Diskette drive A error
Diskette drive B error
Incorrect Drive A type - run SETUP
Incorrect Drive B type - run SETUP
System cache error - Cache disabled
CPU ID:
EISA CMOS not writeable
DMA Test Failed
Software NMI Failed
device Address Conflict
Allocation Error for: device
CD ROM Drive
Entering SETUP...
Failing Bits: nnnn
Fixed Disk n
Invalid System Configuration Data
I/O device IRQ conflict
PS/2 Mouse Boot Summary Screen:
Description
Previous POST did not complete successfully. POST loads default values and offers to run Setup. If the failure was caused by incorrect values and they are not corrected, the next boot will likely fail. On systems with control of wait states, improper Setup settings can also terminate POST and cause this error on the next boot. Run Setup and verify that the waitstate configuration is correct. This error is cleared the next time the system is booted.
Memory size found by POST differed from CMOS.
Drive A: or B: is present but fails the BIOS POST diskette tests. Check to see that the drive is defined with the proper diskette type in Setup and that the diskette drive is attached correctly.
Type of floppy drive A: not correctly identified in Setup.
Type of floppy drive B: not correctly identified in Setup.
RAM cache failed and BIOS disabled the cache. On older boards, check the cache jumpers. You may have to replace the cache. See your dealer. A disabled cache slows system performance considerably.
CPU socket number for
ServerBIOS2 test error: Cannot write to EISA CMOS.
ServerBIOS2 test error: Cannot write to extended DMA (Direct Memory Access) registers.
ServerBIOS2 test error: Cannot generate software NMI
ServerBIOS2 test error:
Address conflict for specified device.
Run ISA or EISA Configuration Utility to resolve resource conflict for the specified device.
CD ROM Drive identified.
Starting Setup program
The hex number nnnn is a map of the bits at the RAM address which failed the memory test. Each 1 (one) in the map indicates a failed bit. See errors 230, 231, or 232 above for offset address of the failure in System, Extended, or Shadow memory.
Fixed disk n
Problem with NVRAM (CMOS) data.
I/O device IRQ conflict error.
PS/2 Mouse installed.