SBI-7426T-S3 Blade Module User’s Manual
Notes
Table 6-12. MPS Configuration Sub-menu
Menu Option
MPS Revision
Description
This option allows you to select the MPS revision used for your system. Options include 1.1 and 1.4.
Table 6-13. PCI Express Configuration Sub-menu
Menu Option
Active State
Description
This option allows you to enable/disable PCI Express L0s and L1 link power in your system. Options include Enabled and DISABLED.
Table 6-14. SMBIOS Configuration Sub-menu
Menu Option
SMI Support
Description
This option enables SMBIOS SMI Wrapper support for
Table | ||
|
| |
Menu Option | Description | |
Remote Access | This option allows you to select your remote access type. Options include COM1 | |
and COM2. | ||
| ||
|
| |
| This option allows you to select a serial port for console redirection if the | |
Serial Port Number | selected port is enabled. Options include COM1 and COM2. | |
The Base Address IRQ is displayed statically under this option for your | ||
| ||
| reference. | |
Serial Port Mode | Use this option to select the serial port mode setting. Options include 115200 | |
8,n,1 / 57600 8,n,1 / 38400 8,n,1 / 19200 8,n,1 / 09600 8,n,1 | ||
| ||
Flow Control | This option allows you to select Flow Control for redirection. Options include | |
None, HARDWARE or SOFTWARE. | ||
| ||
| This option allows you to specify redirection after BIOS POST. Options include | |
| the following: | |
Redirection After | • DISABLE – Turns off the redirection after POST | |
BIOS POST | • BOOT LOADER – Redirection is active during Boot Loader | |
| • Always – Redirection is always active. | |
| NOTE: Some operating systems may not work if set to Always. | |
|
| |
Terminal Type | This option allows you to select the Terminal Type for your system. Options | |
include ANSI, VT100 and | ||
| ||
Use this option to enable | ||
Support | terminals. Options include Enabled and DISABLED. | |
|
| |
Sredir Memory | This option gives the delay in seconds to display memory information. Options | |
Display Delay | include No Delay, DELAY IN 1 SEC, DELAY IN 2 SEC and DELAY IN 4 SEC. | |