SUPER MICRO Computer SBI-7426T-S3 Dimm Installation, Installing a Dimm into a Memory Slot

SBI-7426T-S3 Blade Module User’s Manual

DIMM Installation

WARNING: Exercise extreme care when installing or removing DIMM modules to prevent any possible damage.

Installing DIMM Memory Modules

1.Power down the blade module (see "Powering Down a Blade Unit" on page 3-1).

2.Remove the blade from the enclosure and the cover from the blade (see "Removing/Replacing the Blade Cover" on page 3-2).

3.Remove the air shroud that covers the DIMM slots.

4.Insert each DIMM vertically into its slot, starting with slots 1A and 2A. Pay attention to the notch along the bottom of the module to prevent inserting the DIMM incorrectly (see Figure 3-6).

Figure 3-6. Installing a DIMM into a Memory Slot

To Install: Insert module vertically and press down until it snaps into place. Pay attention to the bottom notch.

To Remove: Use your thumbs to gently push each release tab outward to free the DIMM from the slot.

5.Gently press down on the DIMM until it snaps into place in the slot. Repeat for all modules (see Table 3-1for installing DIMMs into the slots in the correct order).

6.Replace the air shroud and the blade cover and install the blade module back into the enclosure.

7.Power up the blade unit (see "Powering Up a Blade Unit" on page 3-1).

3-8