Leica 769459, 764553, 766558 manual Indirect Measurement determining a distance using, As possible

Indirect measurement - determining a distance using 2 auxilliary measurements

See figure {P}

e.g. for measuring building heights or widths. It is helpful to use a tripod when measuring heights that require the measurement of two or three measurements.

Press this button once, the display shows . The laser is switched

on.

Aim at the upper point (1) and trigger the measurement . After the first measurement the value is adopted. Keep the instrument as hori- zontal as possible.

Press and hold down this button to trigger continuous measurement

, sweep the laser back and forth and up and down over the ideal target point.

Press to stop continuous measurement (2). The result is displayed in the summary line, the partial results in the secondary line.

Press and hold the key to display additional information about the

measurement of the angles of the triangle and .

Press to stop continuous measurement (2). The value is adopted. Aim at the lower point and

press this button to trigger the measurement (3) . The result is displayed in the summary line, the partial results in the secondary lines.

Press and hold the key to display additional information about for

example the partial distances , and the minimum distance .

Indirect measurement - determining a partial value using

3measurements

See figure {R}

e.g. determining the height between point 1 and point 2 using three target points.

Press this button three times ; the display shows the following

symbol . The laser is switched on. Aim at the upper point (1).

Press this button and trigger the measurement . After the first measurement the value is adopted.

Triggers the measurement . After the second measurement the value is adopted.

EN

Indirect Measurement - determining a distance using 3					Press and hold down this button to trigger continuous measurement
measurements
				. Sweep the laser up and down over the ideal target point.
See figure {Q}
					Press this button to end continuous measurement. The result is
	Press this button twice; the display shows the following symbol	.
			displayed in the summary line, the partial results in the secondary lines.
The laser is switched on.
			Press and hold the			key to display additional information about the
	Aim at the upper point (1) and trigger the measurement. After the
			measurement of the partial lengths				and	.
first measurement the value is adopted. Keep the instrument as horizontal
as possible
	Press and hold down this button to trigger continuous measurement
	, sweep the laser up and down over the ideal target point.
Leica DISTO™ D5 LCA782204a en			13					Functions