EN | Storage of constants / historical storage |
Storage of a constant
You can store and recall a frequently used value e.g. height of a room.
Measure the desired distance, press and hold the 
button until the device beeps to confirm storage.
Recalling the constant
Press this button once to recall the constant and then press the 
button to enter it into your calculation.
Historical storage
Press this button twice and the previous 20 results (measurements or calculated results) are shown in reverse order.
The 
and 
buttons can be used for navigation.
Press this button to use a result from the summary line for further calculations.
Pressing the 
and 
buttons at the same time erases all the values in historical storage.
Timer (self-triggering) 
Press this button to set a
Press and hold down this button until the desired time delay is reached (max. 60 seconds).
Once the key is released with the laser activated, the remaining seconds until measurement (e.g. 59, 58, 57...) are displayed in a countdown. The last 5 seconds are counted down with a beep. After the last beep the measu- rement is taken and the value is displayed.
)The timer can be used for all measurements.
Appendix
Message codes
All message codes are displayed with either 
or "Error". The following errors can be corrected:
Cause | Remedy |
156Transverse tilt greater than 10° Hold the instrument without any transverse tilt
160 | Main tilt direction, angle too | Measure angle up to max. ± 45° |
| high (> 45°) |
|
162 | The calibration has not been | Calibrate the device on an abso- |
| accomplished on a leveled | lute horizontal leveled surface. |
| surface and the calibration value |
|
| is respecitvely within an |
|
| ineligible area. |
|
204 | Calculation error | Repeat procedure |
252 | Temperature too high | Cool down instrument |
253 | Temperature too low | Warm up instrument |
255 | Receiver signal too weak, | Use target plate |
| measurement time too long, |
|
| distance > 100 m |
|
256 | Received signal too strong | Target too reflective (use target |
|
| plate) |
257 | Wrong measurement, | Darken target (measure in diffe- |
| background brightness too high | rent lighting conditions) |
260 | Laser beam interrupted | Repeat measurement |
|
|
|
Error | Cause | Remedy |
Error | Hardware error | Switch on/off the device several |
|
| times. If the symbol still appears, |
|
| then your instrument is defec- |
|
| tive. Please call your dealer for |
|
| assistance. |
Appendix
14
Leica DISTO™ D5 LCA782204a en