Sears 919.727321 owner manual Important Safety Instructions, Hazard, Risk of Explosion or Fire

Page 3

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

IMPROPER OPERATION OR MAINTENANCE OF THIS PRODUCT COULD RESULT IN SERIOUS INJURY AND PROPERTY DAMAGE. READ AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFORE USING THIS EQUIPMENT.

HAZARD

RISK OF EXPLOSION OR FIRE

WHAT CAN HAPPEN

HOW TO PREVENT IT

IT IS NORMAL FOR ELECTRICAL CONTACTS WITHIN THE

ALWAYS OPERATE THE COMPRESSOR IN A WELL VENTI-

MOTOR AND PRESSURE SWITCH TO SPARK.

LATED AREA FREE OF COMBUSTIBLE MATERIALS,

 

GASOLINE OR SOLVENT VAPORS.

IF ELECTRICAL SPARKS FROM COMPRESSOR COME INTO

IF SPRAYING FLAMMABLE MATERIALS, LOCATE COMPRES-

CONTACT WITH FLAMMABLE VAPORS, THEY MAY IGNITE,

SOR AT LEAST 20 FEET AWAY FROM SPRAY AREA. AN

CAUSING FIRE OR EXPLOSION.

ADDITIONAL LENGTH OF HOSE MAY BE REQUIRED.

 

STORE FLAMMABLE MATERIALS IN A SECURE LOCATION

 

AWAY FROM COMPRESSOR.

RESTRICTING ANY OF THE COMPRESSOR VENTILATION

NEVER PLACE OBJECTS AGAINST OR ON TOP OF COM-

OPENINGS WILL CAUSE SERIOUS OVERHEATING AND

PRESSOR. OPERATE COMPRESSOR IN AN OPEN AREA AT

COULD CAUSE FIRE.

LEAST 12 INCHES AWAY FROM ANY WALL OR OBSTRUC-

 

TION THAT WOULD RESTRICT THE FLOW OF FRESH AIR TO

 

THE VENTILATION OPENINGS.

 

OPERATE COMPRESSOR IN A CLEAN, DRY, WELL VENTI-

 

LATED AREA. DO NOT OPERATE UNIT INDOORS OR IN ANY

 

CONFINED AREA.

UNATTENDED OPERATION OF THIS PRODUCT COULD RESULT IN PERSONAL INJURY OR PROPERTY DAMAGE.

ALWAYS REMAIN IN ATTENDANCE WITH THE PRODUCT WHEN IT IS OPERATING.

RISK OF BURSTING

AIR TANK: THE FOLLOWING CONDITIONS COULD LEAD TO A WEAKENING OF THE TANK, AND RESULT IN A

VIOLENT TANK EXPLOSION AND COULD CAUSE PROPERTY DAMAGE OR SERIOUS INJURY.

WHAT CAN HAPPEN

HOW TO PREVENT IT

1. FAILURE TO PROPERLY DRAIN CONDENSED WATER

DRAIN TANK DAILY OR AFTER EACH USE. IF TANK DEVEL-

FROM THE TANK, CAUSING RUST AND THINNING OF THE

OPS A LEAK, REPLACE IT IMMEDIATELY WITH A NEW TANK OR

STEEL TANK.

REPLACE THE ENTIRE COMPRESSOR.

2.MODIFICATIONS OR ATTEMPTED REPAIRS TO THE TANK. NEVER DRILL INTO, WELD, OR MAKE ANY MODIFICATIONS TO THE TANK OR ITS ATTACHMENTS.

3.

UNAUTHORIZED MODIFICATIONS TO THE UNLOADER

THE TANK IS DESIGNED TO WITHSTAND SPECIFIC OPERATING

 

VALVE, SAFETY VALVE, OR ANY OTHER COMPONENTS

PRESSURES. NEVER MAKE ADJUSTMENTS OR PARTS

 

WHICH CONTROL TANK PRESSURE.

SUBSTITUTIONS TO ALTER THE FACTORY SET OPERATING

 

 

PRESSURES.

4.

EXCESSIVE VIBRATION CAN WEAKEN THE AIR TANK

 

 

AND CAUSE RUPTURE OR EXPLOSION.

 

ATTACHMENTS & ACCESSORIES:

FOR ESSENTIAL CONTROL OF AIR PRESSURE, YOU MUST

EXCEEDING THE PRESSURE RATING OF AIR TOOLS, SPRAY

INSTALL A PRESSURE REGULATOR AND PRESSURE GAUGE

GUNS, AIR OPERATED ACCESSORIES, TIRES AND OTHER

TO THE AIR OUTLET OF YOUR COMPRESSOR. FOLLOW THE

EQUIPMENT MANUFACTURERS RECOMMENDATION AND

INFLATABLES CAN CAUSE THEM TO EXPLODE OR FLY

APART, AND COULD RESULT IN SERIOUS INJURY.

NEVER EXCEED THE MAXIMUM ALLOWABLE PRESSURE

RATING OF ATTACHMENTS. NEVER USE COMPRESSOR TO

 

 

INFLATE SMALL LOW-PRESSURE OBJECTS SUCH AS

 

CHILDREN’S TOYS, FOOTBALLS, BASKETBALLS. ETC.

 

 

3 — ENG

D20015 Rev. 1 6/28/00

Image 3
Contents Model No Safety Guidelines Definitions Table of ContentsRisk of Explosion or Fire Important Safety InstructionsWhat can Happen HOW to Prevent IT HazardRisk from Flying Objects Risk to BreathingRisk of Electrical Shock Risk of Falling Risk of Property Damage When Transporting CompressorRisk from Moving Parts Risk of BurnsModel No 919.727321 Specification ChartGeneral Information GlossaryDescription of Operation Tools Needed for AssemblyBREAK-IN Procedures AssemblyExtension Cords Operating ProceduresFilter Retainer MaintenanceProblem Cause Correction Troubleshooting GuideHave compressor checked at Sears Service Center Service and Repair Parts 919.727321 Table DES Matières Mesures DE Sécurité DéfinitionsGarantie Complète DUN AN SUR LES Compresseurs Dair Sears Risque D’ÉCLATEMENT Mesures DE Sécurité ImportantesAvertissement Risque D’EXPLOSION OU D’INCENDIERisque DE Projection D’OBJETS Prévention Risque PAR Inhalation PréventionRisque DE Choc Électrique Prévention Risque Relié AUX Pièces Mobiles Risque DE BrûluresRisque DE Chute De modèle 919.727321 Information GénéraleGlossaire Tableau DES SpécificationsOutils Nécessaires À L’ASSEMBLAGE Description DU FonctionnementProcédés DE Rodage AssemblageMise EN Marche RallongesDirectives de rodage Entretien Guide DE DÉ Pannage Problème Cause SolutionDu compresseur DE Modèle Entretien Pour Commander DES Pièces DE Rechange