Sears 113.21371 manual Assembty, Mounting the Motor

Page 10

assembty

NOTE: When using motors which have Y2" dia. shafts, place the adapter sleeve (furnished with the motor) on the shaft so that the slot in the sleeve is over the flat spot.

4.Insert the shaft key (furnished with motor) into the grooves in the shaft and pulley so that the end of the key is even with the end of the shaft,

5.Tighten the set screw. Use a pair of pliers on the short end of the set screw wrench for increased leverage.

MOUNTING THE MOTOR

1, Position the motor mount as shown and place the motor on top of it.

2, Find four 5/16 in.--18 x 1 in. CARRIAGE BOLTS, flat wash_;rs and hex. nuts, among the loose parts.

3, Insert the bolts as shown ,.. install washers . .. screw

on nuts but DON'T TIGHTEN them:

"_/}6 y 3/16 KEY

FLAT SPOT

 

 

I

1/2

IN. DIA.

EEVE

MOTOR

SHAFT

 

RRIAGE BOLT

4.Using a 5/32 inch set screw wrench unscrew the PIVOT screws as shown,

_

SCREW

10

Image 10
Contents Drill Press only Model no113.213710 DRI LL Press with HP MotorOr power tools Attempt to Operate Your Drill Press Until Additionam safety instructions for drill pressesFor Your OWN SAFETY, do not YOU have Read and Understand FollowingAdditional safety instructions for drill presses Unpacking checkingCutting Tool Connecting to Power Source OutletRPM Volts Catalog no Check Motor RotationAssembly Spindle Nose Locking Collar Chuck Chuck KEY Chuck Body Raising the Head Installing the Depth StopScrew the Thumb Screw partways into the Depth Pointer Tighten the Quill Lock Handle Installing Motor Pulley10, Tighten the Head Lock Handle and the Quill Lock Handle Keyway GrooveAssembty Mounting the MotorExcessive Tightness could Bend the Motor Mount Grease Installing and Tensioning BeltBelt Tensioning ROD Getting Know Your Drill Press Spindle Speed ChartThumbscrew Tablelock Handle ,, locks the table to the column Getting to know your drill pressHead Lock Handle ... locks the head to the column Another WAYRemovingthe Chuck Back onOperation Observe the Following Safety PrecautionsInstalling Drills Positioning Table and WorkpieceHole LOCAT!ON AdiustmentsBelt Tension Outlet Before Maintaining or Lubricating Your Drill Press Recommended accessoriesLubrication WheelTrouble shooting Outlet Before Trouble ShootingParts List for Craftsman Drill Press Model no .21371 STD Parts List for Craftsman Drill Press Model no .21371STD RPMParts List for Craftsman Drill Press KeyParts List for Craftsman Drill Press Model no .21371 71075 Spindle ASSEMBLY, StopModel Number Name 113.2!3710Part Inch Drill