Sears 113.21371 manual Excessive Tightness could Bend the Motor Mount

Page 11

5, Remove the belt guard by "pushing in" on the two "links".

6, Place motor on drill press ... screw the pivot screws into the holes.

NOTE: DO NOT SCREW THEM IN TOO TIGHT ,..

EXCESSIVE TIGHTNESS COULD BEND THE MOTOR MOUNT.

7, Find two 5/16 in-18 hex. nuts among the loose parts

... screw them on to the pivot screws ... tighten

them with a Y2 in. wrench while preventing the pivot screws from turning.

8.Plug motor cord into outlet inside of drill press.

9.Find the plastic CORD TIE among the loose parts ...

insert the pointed end into the hole in the motor mount.

10.Gather up the slack in the motor cord.., wrap the CORD TIE around it., . insert one end of the TIE into

the hole in the other end. Pull it tightly to secure the cord to the motor mount.

CAUTION: If you are using a DOUBLE SHAFT motor.

Make sure the SHAFT PROTECTOR is installed. NEVER

USE THE DRILL PRESS WiTH THE UNUSED SHAFT EXPOSED.

1t

Image 11
Contents DRI LL Press with HP Motor Model no113.213710 Drill Press onlyOr power tools YOU have Read and Understand Following Additionam safety instructions for drill pressesFor Your OWN SAFETY, do not Attempt to Operate Your Drill Press UntilUnpacking checking Additional safety instructions for drill pressesCheck Motor Rotation Connecting to Power Source OutletRPM Volts Catalog no Cutting ToolAssembly Spindle Nose Locking Collar Chuck Chuck KEY Chuck Body Screw the Thumb Screw partways into the Depth Pointer Installing the Depth StopRaising the Head Keyway Groove Installing Motor Pulley10, Tighten the Head Lock Handle and the Quill Lock Handle Tighten the Quill Lock HandleMounting the Motor AssembtyExcessive Tightness could Bend the Motor Mount Belt Tensioning ROD Installing and Tensioning BeltGrease Thumbscrew Spindle Speed ChartGetting Know Your Drill Press Another WAY Getting to know your drill pressHead Lock Handle ... locks the head to the column Tablelock Handle ,, locks the table to the columnBack on Removingthe ChuckPositioning Table and Workpiece Observe the Following Safety PrecautionsInstalling Drills OperationBelt Tension AdiustmentsHole LOCAT!ON Wheel Recommended accessoriesLubrication Outlet Before Maintaining or Lubricating Your Drill PressOutlet Before Trouble Shooting Trouble shootingParts List for Craftsman Drill Press Model no .21371 RPM Parts List for Craftsman Drill Press Model no .21371STD STDKey Parts List for Craftsman Drill Press71075 Spindle ASSEMBLY, Stop Parts List for Craftsman Drill Press Model no .21371Inch Drill 113.2!3710Part Model Number Name