REMOVINGTHE CHUCK.
1, Insert apiece of 1/4 in. alia. steel rod in one of the holes in the chuck body,
2.insert the CHUCK KEY into one of the hoIes in the
collar ... turn it in the direction of arrow until LOOSE. Continue to turn it until the chuck is released.
FEATUREIS INTENDEDTO PREVENT
UNAUTHORIZED AND POSSIBLE HAZARDOUS USE
BY CHILDREN AND OTHERS.
switch. This permits the light to be "on" while making ,!our setups.
Insert KEY into switch. NOTE: Key is made, of yellow plastic.
To turn drill ON ..
Insert finger under switch lever and pull.
TO turn drill OFF ... Push lever in.
In an emergency; .,. the drill bit BINDS .. , STALLS ,..
STOPS ... or tends to tear the workpiece loose ,.. you
can QUICKLY turn the drill OFF by hitting the switch with the palm of your hand,
TO lock switch in OFF position .., hold switch iN with one hand . .. REMOVE key with other hand,
WARNING: FOR YOUR OWN SAFETY, ALWAYS LOCK
THE SWITCH "OFF" WHEN DRILL PRESS IS NOT IN
USE ... REMOVE KEY AND KEEP IT IN A SAFE
PLACE ... ALSO ... IN THE EVENT OF A POWER
FAILURE (ALL OF YOUR LIGHTS GO OUT) TURN SWITCH OFF .o. LOCK IT AND REMOVE THE KEY.
THIS WILL PREVENT THE DRILL PRESS FROM
STARTING UP AGAIN WHEN THE POWER COMES
BACK ON.
!5