Sears 28.71234 operating instructions Charger features Assembly instructions, Parts Tools Needed

Page 10

10.charger features

11.Assembly instructions

It is important to fully assemble your charger before use. Follow these instructions for assembly:

PARTS	TOOLS NEEDED
Two, 10-32, thread cutting screws	3/8” wrench (for mounting foot)
Four, 1/4-20, thread cutting screws	5/16” wrench (for wheels)
Two wheels	Hammer
One axle	Phillips screwdriver
Two axle caps
Two axle brackets
One handle
One handle grip
One mounting foot

• 8 •

Image 10

Contents OPERATOR’S Manual Table of Contents Important Safety Instructions Personal Precautions Preparing to ChargeFollow These Steps When Battery is Installed in ve- hicle DC Connection PrecautionsCharger Location Page Page Grounding Methods Replacement Parts List DieHard Description Part Number PartsCharger features Assembly instructions Parts Tools NeededTo attach the axle assembly Page Power ON/OFF Switch Using the gfci outletSetting the Controls Battery Voltage SelectMaximum SettingsRate Time IncrementCharge Rate in amps Charger is in Manual modeVoltage There is a problem with the battery or connections Battery is charged Automatic modeTimer mode Engine StartAmp Hours = Reserve Capacity + Charge Rate Battery SIZE/RATING Charging Time Hours AMPSpecific Gravity Percent of Charge Needed Using the engine start feature Charger SettingCharger Setting Hours ExampleMaintenance instructions Storage instructionsTroubleshooting Problem Possible Cause SOLUTION/REASONSWarranty THREE-YEAR Full WarrantyPage