Sears 28.71234 operating instructions

Page 6

6.6For positive-grounded vehicle, connect NEGATIVE (BLACK) clip from bat- tery charger to NEGATIVE (NEG, N, –) ungrounded post of battery. Con- nect POSITIVE (RED) clip to vehicle chassis or engine block away from battery. Do not connect clip to carburetor, fuel lines, or sheet-metal body parts. Connect to a heavy gauge metal part of the frame or engine block.

6.7When disconnecting charger, turn switches to off, disconnect AC cord, remove clip from vehicle chassis, and then remove clip from battery termi- nal.

6.8See OPERATING INSTRUCTIONS for length of charge information.

7.FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE.

A SPARK NEAR THE BATTERY MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A SPARK NEAR BATTERY:

7.1Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has a larger diameter than NEGATIVE (NEG, N, –) post.

7.2Attach at least a 24-inch-long 6-gauge (AWG) insulated battery cable to NEGATIVE (NEG, N, –) battery post.

7.3Connect POSITIVE (RED) charger clip to POSITIVE (POS, P, +) post of battery.

7.4Position yourself and free end of cable as far away from battery as pos- sible – then connect NEGATIVE (BLACK) charger clip to free end of cable.

7.5Do not face battery when making final connection.

7.6When disconnecting charger, always do so in reverse sequence of con- necting procedure and break first connection while as far away from bat- tery as practical.

7.7A marine (boat) battery must be removed and charged on shore. To charge it onboard requires equipment specially designed for marine use.

4

Image 6
Contents OPERATOR’S Manual Table of Contents Important Safety Instructions Personal Precautions Preparing to ChargeDC Connection Precautions Follow These Steps When Battery is Installed in ve- hicleCharger Location Page Page Grounding Methods Replacement Parts List DieHard Description Part Number PartsCharger features Assembly instructions Parts Tools NeededTo attach the axle assembly Page Power ON/OFF Switch Using the gfci outletSetting the Controls Battery Voltage SelectMaximum SettingsRate Time IncrementCharger is in Manual mode Charge Rate in ampsVoltage There is a problem with the battery or connections Battery is charged Automatic modeTimer mode Engine StartCharge Rate Battery SIZE/RATING Charging Time Hours AMP Amp Hours = Reserve Capacity +Specific Gravity Percent of Charge Needed Using the engine start feature Charger SettingCharger Setting Hours ExampleMaintenance instructions Storage instructionsTroubleshooting Problem Possible Cause SOLUTION/REASONSWarranty THREE-YEAR Full WarrantyPage