Sears 28.71234 operating instructions To attach the axle assembly

Page 11

To attach the axle assembly:

11.1Remove charger from packing materials and place upside down on a flat surface. Attach mounting foot and secure with the four, 1/4-20 thread cut- ting screws.

11.2Hold axle upright on floor or work surface. Then, using a hammer, tap one of the plastic axle caps onto the top end of the axle. Be sure to tap the axle cap on straight. Slide both wheels onto the axle with the axle caps facing each other.

• 9 •

Image 11

Contents OPERATOR’S Manual Table of Contents Important Safety Instructions Preparing to Charge Personal PrecautionsCharger Location DC Connection PrecautionsFollow These Steps When Battery is Installed in ve- hicle Page Page Grounding Methods Parts Replacement Parts List DieHard Description Part NumberParts Tools Needed Charger features Assembly instructionsTo attach the axle assembly Page Battery Voltage Select Using the gfci outletSetting the Controls Power ON/OFF SwitchTime Increment SettingsRate MaximumVoltage Charger is in Manual modeCharge Rate in amps Engine Start Battery is charged Automatic modeTimer mode There is a problem with the battery or connectionsSpecific Gravity Percent of Charge Needed Charge Rate Battery SIZE/RATING Charging Time Hours AMPAmp Hours = Reserve Capacity + Example Charger SettingCharger Setting Hours Using the engine start featureStorage instructions Maintenance instructionsProblem Possible Cause SOLUTION/REASONS TroubleshootingTHREE-YEAR Full Warranty WarrantyPage