Sears 28.71234 operating instructions Rate, Maximum, Time Increment, Hour, Settings

6 VOLT when charging, testing or starting 6 volt systems.

13.3TOUCH‑PAD CONTROLS

With your charger connected to the vehicle and power source, the battery voltage (6 or 12 volt) selected, and the power turned ON, select either AU- TOMATIC or MANUAL charge and the rate at which you want to charge your battery (2, 20, or 60 amp).

•AUTO (Automatic): When first turned ON, the charger will be in the Manual mode. Touch the AUTO pad and either the 2, 20, or 60 AMP

Charge Rate Selector pad. Charging will start after a short delay. It will stop when the battery is fully charged. While charging, the METER will show battery voltage. Touch the VOLTS/AMPS pad to see the amount of amps being drawn by the battery.

•MANUAL: When first turned on, the charger will be in the Manual mode

‑ there will be no need to select MANUAL. Select a charge rate and time. The charger will start charging after a short delay. It will stop charging only when the selected time or maximum time is up. For this reason, it is IMPORTANT to check the charger frequently to avoid overcharging the battery. While charging, the METER will show battery voltage. To see how much of the selected charge time is remaining, touch the TIME pad. The METER will show the time and, after a short delay, return to showing voltage. To see the amount of amps being drawn by the battery, touch the VOLTS/AMPS pad.

•TIME: To select a charging time, you must be in the MANUAL mode and have selected a charge rate. Touch the TIME pad until the desired time shows on the meter. The following chart shows the amount of time avail- able for each charge rate and the amount of time, in hours, added for each touch of the TIME pad.

• 12 •