Subaru Robin Power Products R1300 manual Oil

Page 15

[Judgement of oil level]

When sufficient oilis in the crankcase, bothof inner and outer electrodes are immersed in the oil through

whichcurrentflowsacrosstheelectrodes.Thesensorjudgesthatoil in the crankcase is sufficient. 4 When oil level goes down and the inner electrode is exposed to the air due to consumption of oil, no current flow between the electrodes as isairconsidered to be electrically non-conductive.

The sensor in this case judges that oilis insufficient.

[Decision of oil shortage]

Oil level at the electrodesmay go down momentarily probably due to the engine being slantedor affected by vibration even if a sufficient oil isin the crankcase.

For that reason, the sensor has an electronic timer circuit to prevent it from interpreting as short of oil when amount of oil is sufficient. The sensor has been designed so that the engine is to be stopped only when oil-shortage is detected for 5 seconds uninterrupted.

The timer employs an integration circuitand it is to be reset when the inner electrode is soaked in the oil again before the sensor decidesit as oil-shortage.

The oillevelwhere the sensordecides as oil-shortage, when oil level goesdowngradually, is called “threshold level”.

[Automatic stopof engine]

When the sensor decides as oil-shortage, it makes the engine tostop running automatically for protection of engine.

Once the stopping circuit is activated, it keeps functioning until it confirms that the engine has made a

complete stop, thenthe circuit stops functioning automatically.

e

 

5-5-4BLOCK DIAGRAM OFTHE CIRCUIT

 

 

 

Power circuit

Igniter

 

 

 

LED indicator

Innerpole -

Detection

- Deley circuit

Stopping

circuit

 

circuit

oil I

 

 

 

Outer pole

 

 

Engine

 

 

Fig. 5-1 1

 

0Power circuit ---- * - *This---- rectifies a part of power to the igniter

and regulates it to supply the -1

 

stabilized power to necessary circuits.

 

- 13-

Image 15 Contents
Model Section Title 1300 W SpecificationsPerformance Curves Features 1EXTERNAL View of Generator General DescriptionTank Construction and Function \ \2CONDENSER Control Panel Voltagefluctuationsunderload DC Output 4ELECTRONIC Ignition System OIL Sensor Option 1DESCRIPTION Oil 5CAUTIONS to be Taken on Handling the Sensor Operator may be injured or suffer electric shock Incandescent lamp, heater, etc. withapower factorof 1.O Appliances without any indication asto power consumption Specific Gravity of Batteryelectrolyte 3BATTERY Capacity Time to change batteries Measuringprocedures3METERFREQUENCY Circuittester IPI Measuring Insulation Resistance Control Panel Checkingfunctionalmembers DC Terminal Measure the resistance of the resister 10 ,uF Checkingtableforanaloguecircuittester Disassembly and Assembly 10-2DISASSEMBLY Procedures Green Driver + Driver Two M8 nuts LOmm box wrench 12mm box wrench + Driver LOmm box wrench Box spanner Stator Rotor Rotor Screw the bolt into the thread Mount Remove mount bracketfrom engine Assemblyprocedures 10-3-1FRONT Bracket Stator 10-3-5ENDCOVER 10-3-9FRONT Cover and Element Cover Control Panel Side Secure the side cover with four M5X8 screws Remedy 11= TroubleshootingMow to adjustengine r.p.m AC circuit breaker Resistor RobinAmerica, Inc
Related manuals
Manual 54 pages 20.02 Kb