Subaru Robin Power Products R1300 manual Checkingfunctionalmembers

Page 28

9.CHECKINGFUNCTIONALMEMBERS

9-1 CONTROL PANEL

Fig. 9-1

9-1-1ACRECEPTACLES

Using a “Dr. Robin”or a circuit tester, check continuity between the two terminals at the rear of the AC receptacles while the receptacle is mounted on the control panel. When continuity is found between the output terminals of thereceptaclewith a wire connected acrossthese terminals, theACreceptacle is normal. When the wire is removed and no continuity is found between these terminals, the receptacles are alsonormal.

-

Fig. 9-2A

Fig. 9-26

 

 

- 26 -

Image 28
Contents Model Section Title Specifications 1300 WPerformance Curves Features General Description 1EXTERNAL View of GeneratorTank \ \ Construction and Function2CONDENSER Control Panel Voltagefluctuationsunderload DC Output 4ELECTRONIC Ignition System OIL Sensor Option 1DESCRIPTION Oil 5CAUTIONS to be Taken on Handling the Sensor Operator may be injured or suffer electric shock Incandescent lamp, heater, etc. withapower factorof 1.O Appliances without any indication asto power consumption Specific Gravity of Batteryelectrolyte 3BATTERY Capacity Measuringprocedures Time to change batteries3METERFREQUENCY Circuittester IPI Measuring Insulation Resistance Control Panel Checkingfunctionalmembers DC Terminal Measure the resistance of the resister 10 ,uF Checkingtableforanaloguecircuittester Disassembly and Assembly 10-2DISASSEMBLY Procedures Green Driver + Driver Two M8 nuts LOmm box wrench 12mm box wrench + Driver LOmm box wrench Box spanner Stator Rotor Rotor Screw the bolt into the thread Mount Remove mount bracketfrom engine Assemblyprocedures 10-3-1FRONT Bracket Stator 10-3-5ENDCOVER 10-3-9FRONT Cover and Element Cover Control Panel Side Secure the side cover with four M5X8 screws 11= Troubleshooting RemedyMow to adjustengine r.p.m AC circuit breaker Resistor RobinAmerica, Inc