Subaru Robin Power Products R1300 manual Stator

10-3-3 STATOR

Holding the rear bracket and stator, fit them to

thefrontbracket.Matchthe mounting hole of

the rearbracketandthat of therotor bearing, and softly strike the outsideperiphery of the rear bracket with a plastic hammer.

(See Fig. 10-31.)

Attach the stator cover around the stator.

Fig. 10-31

Tighten the three M6 boll i to fix the rearbrack- et to the front bracket.

TIGHTENINGTORQUE 4.0 - 5.4ft Ibs. 535 - 735 N cm 55 - 75kg-cm

(4)Put the grommet in the grooveof the rear bracket and secure the wire.

Note :Fix the wire from the stator and diode stack with theclamp at the bottom of the groove.

10-3-4CONDENSER

Put condenser to rear cover.

5 0 X 10mm tapping Screw ----..----*.2----pcs...

TIGHTENINGTORQUE 2.4 - 4.0 ft - Ibs. 325 - 535 N cm

55 kg cm

Condenser

Fjg. 10-32

-43-