Subaru Robin Power Products R1300 manual Ipi

Page 25

8-2AC OUTPUT MEASURING

4

To AC receptacle

Fig. 8-8

Measurement is executedwith the circuit as shown in Fig. 8-8.An electricheateroran incandescent lamp with a power factorof 1.0 is suitable as a load for the generator. When the AC output measured at the rated load and rated speed is confirmed to be within the voltage range specified in the table below, the AC output is normal.

IvoltageRated	I	120v	I
Voltage range		117-1 30V

Table 8-2

8-3DC OUTPUT MEASURING

To DC Terminal

-l

IPI

Fig. 8-9

Measurement of DC output is executed with the switchturned ON while the current isregulated at 8.3A by adjustingtheloadtothegenerator. If thevoltage is withinthe range from 6V to 14V,thevoltage output is normal.

Note : If a battery is connected as a loadtothegenerator,the DC outputvoltagewillincreaseby approximately I to 2V. Therefore, carefully observe the electrolyte level and do not overcharge the battery.

- 23 -

Image 25

Contents Model Section Title 1300 W SpecificationsPerformance Curves Features 1EXTERNAL View of Generator General DescriptionTank Construction and Function \ \2CONDENSER Control Panel Voltagefluctuationsunderload DC Output 4ELECTRONIC Ignition System OIL Sensor Option 1DESCRIPTION Oil 5CAUTIONS to be Taken on Handling the Sensor Operator may be injured or suffer electric shock Incandescent lamp, heater, etc. withapower factorof 1.O Appliances without any indication asto power consumption Specific Gravity of Batteryelectrolyte 3BATTERY Capacity Time to change batteries Measuringprocedures3METERFREQUENCY Circuittester IPI Measuring Insulation Resistance Control Panel Checkingfunctionalmembers DC Terminal Measure the resistance of the resister 10 ,uF Checkingtableforanaloguecircuittester Disassembly and Assembly 10-2DISASSEMBLY Procedures Green Driver + Driver Two M8 nuts LOmm box wrench 12mm box wrench + Driver LOmm box wrench Box spanner Stator Rotor Rotor Screw the bolt into the thread Mount Remove mount bracketfrom engine Assemblyprocedures 10-3-1FRONT Bracket Stator 10-3-5ENDCOVER 10-3-9FRONT Cover and Element Cover Control Panel Side Secure the side cover with four M5X8 screws Remedy 11= TroubleshootingMow to adjustengine r.p.m AC circuit breaker Resistor RobinAmerica, Inc