Hobart Welding Products OM-945 194 047U manual Specifications, Symbol Definitions

SECTION 3 − DEFINITIONS

3-1. Symbol Definitions

	Stop Engine		Fast		Fast/Slow		Slow (Idle)
			(Run, Weld/Power)		(Run/Idle)
	Start Engine		Read Operator’s	A	Amperes	V	Volts
			Manual
	Engine Oil		Fuel		Battery (Engine)		Engine
	Engine Choke		Check Valve		Circuit Breaker		Temperature
			Clearance
	Positive		Negative		Alternating Current		Output
					(AC)
h	Hours	s	Seconds		Time		Protective Earth
							(Ground)
	Welding Arc		Stick (SMAW)		Fuse
	(Electrode)

SECTION 4 − SPECIFICATIONS

4-1. Weld, Power, and Engine Specifications

Note	This unit uses either an Onan or a Kohler engine. Differences between models are noted
	throughout this manual.
Welding	Weld Output	Rated	Maximum	Single-Phase	Fuel
		Welding	Open Circuit			Engine
Mode	Range			Generator Power Rating	Capacity
		Output	Voltage
		230 A, 25 V,				Onan
		30% Duty		Peak: 10 kVA/kW,		Air-Cooled, Two-Cylinder,
		Cycle				Four-Cycle, 20.5 HP
				84/42 A,
		210 A, 25 V,				Gasoline Engine
				120/240 V AC,	10 gal
CC/DC	50 − 230 A	60% Duty	73	60 Hz		or
					(38 L) Tank
		Cycle				Kohler CH-20
		170 A, 25 V,		Continuous: 9.5 kVA/kW
						Air-Cooled, Two-Cylinder,
		100% Duty		(while not welding)		Four-Cycle, 20 HP
		Cycle				Gasoline Engine

OM-945 Page 9