Southbend SB1017 owner manual Installing belt

11.Pivot the motor assembly upward, then place the belt over the gearbox and motor pulleys, as shown in Figure 15.

Motor Pulley

Gearbox

Pulley

Motor

Assembly

Figure 15. Installing belt.

12.Install the pulley cover (Figure 16) with two M6-1 x 12 hex bolts, three 6mm flat washers, and the South Bend cast aluminum knob (see Figure 17).

Figure 16. Pulley cover.

Knob Location

Figure 17. Pulley cover knob.

13.Slide the vise handwheel onto the leadscrew and tighten the set screw shown in Figure 18. Thread the handle into the handwheel and tighten it.

Leadscrew

Handle

Set Screw

Handwheel

Figure 18. Vise handwheel.