Delta 36-240 Adjusting Table Extensions Auxiliary Fences, Using Auxiliary Fence AS a Stock Stop

ADJUSTING TABLE

EXTENSIONS AND

AUXILIARY FENCES

(FOR MODEL 36-250 ONLY)

Table extensions, one of which is shown at (A) Fig. 52, are provided on each end of the saw stand to support extra long workpieces. To move the table extensions, loosen the two lock screws (B), pull out table extension

(A)to desired position and tighten lock screws (B). The top surface of the table extension (A) is slightly lower than the saw table and adequately supports just about any size of workpiece that fits into the saw.

An auxiliary fence (C) Fig. 53, is provided on each table extension and should be adjusted in line with the saw fence (E) by loosening screw (D) and sliding auxiliary fence (C) until it contacts the workpiece as shown.

N O T E : M A X I M U M L O A D P E R E A C H TA B L E EXTENSION IS 50 POUNDS.

B

B

A

Fig. 52

E

C D

Fig. 53

USING AUXILIARY FENCE AS A STOCK STOP

(FOR MODEL 36-250 ONLY)

B A

Fig. 54

The auxiliary fence (A) can be used as a cut-off gage or stock stop when cutting a number of pieces to the same length, as shown in Fig. 54. Loosen screw (B) and slide fence (A) forward to support and stop the workpiece. Then tighten screw (B).

19