G
Fig. 62
5.Slide the two nuts (G) Fig. 62, out of the channel to the right. The two nuts remaining in the front channel must be removed in the same manner.
6.Loosen two screws (H) Fig. 63, and slide table extension assembly (J) off rods (S). Remove table extension from other end of saw in the same manner.
7.Assemble the four mounting feet to the bottom channels of the saw as follows:
J
S H
H S
Fig. 63
8.When using the saw on a workbench (See Fig. 68), assemble the mounting feet (K) to the channels, as shown in Fig. 64, and tighten screws (L). Assemble the remaining two mounting feet to the other side of the machine in the same manner.
9.When using the saw on saw horses or 2 x 4 extensions (See Figures 70 and 71), assemble the mounting feet (M) to the channels as shown in Fig. 65, and tighten screws (N). Assemble the remaining two mounting feet to the other side of the machine in the same manner.
L
L
K
N
M
Fig. 64 | Fig. 65 |
22