Delta 36-240, 36-250 instruction manual Fastening the SAW to a Workbench, For ALL Models

Page 23

10.If using the saw on a workbench (See Fig. 68) or on saw horses (See Fig. 70), re-assemble the two table extensions, one of which is shown at (J) Fig. 66, that were removed in STEP 6. If you are using the saw on

2x 4 wooden extensions (See Fig. 71), push in the four table extension rods, two of which are shown at (O) Fig. 66, and lock in place. In this case it is not necessary to replace the table extensions (J).

O

O

J

Fig. 66

FASTENING THE SAW TO A WORKBENCH

(FOR ALL MODELS)

Figs. 67 and 68, illustrate the slide saw fastened to a workbench. Holes provided in the base of the units (A) Fig. 67 and (B) Fig. 68, are used to mount the machines to a supporting surface using standard hardware. FOR MODEL 36-250 ONLY: Please note that the table extensions and auxiliary fences (A) Fig. 68, can also be used.

A

Fig. 67

A

A

B

Fig. 68

23

Image 23

Contents Sidekick Compound Slide Saw Always Wear EYE Protection Safety RulesAdditional Safety Rules for Compound Slide Saws Grounding Instructions Connecting Tool to Power SourcePower Connections Motor SpecificationsOperating Instructions Unpacking and CleaningExtension Cords Bench Model Stand Model AssemblyPage For models 36-240 Moving Cuttinghead to the Rear PositionAssembling Dust Elbow and Dust BAG Raising CuttingheadAssembling Work Clamp Moving Table to the 90 Degree CUT-OFF PositionRotating Table for Miter Cutting Operating Controls and AdjustmentsLocking Switch OFF Position Starting Stopping MachineAdjusting Clamping Action Table Locking Mechanism Table Hazard Area Adjusting Sliding FIT Between Movable Table and BaseAdjusting Fence Degrees to Blade Tilting Cuttinghead for Bevel Cutting Work Clamp OperationAdjusting Sliding FIT Between Trunnion and Bevel Bracket Adjusting 90 and 45 Degree Bevel Positive Stops Adjusting Sliding FIT Between Upper ARM and Trunnion Adjusting Blade GuardAdjusting Tension of Cuttinghead Return Spring Tool Storage Adjusting Downward Travel SAW BladeAdjusting Sliding FIT Between Guide Rods and Table Assembly Locking Cuttinghead Guide RodsUsing Auxiliary Fence AS a Stock Stop Adjusting Table Extensions Auxiliary FencesFolding Stand For Transportation Removing SAW from Stand Page For ALL Models Fastening the SAW to a WorkbenchUsing SAW with 2 X 4 Extensions Using the SAW on SAW HorsesReplacing SAW On Stand Correct Operating Procedure for Slide CuttingOperation Page Dado Cutting Using the Work Clamp and Stock StopUsing SAW AS Chop SAW Cutting Crown Moulding Changing the Blade MaintenanceBrush Inspection and Replacement PARTS, Service or Warranty Assistance AccessoriesPage Canadian PORTER-CABLE Delta Service Centers