Fig. 59 | Fig. 60 |
6.Fig. 59, illustrates the stand in the folded position.
7.When moving the saw from place to place, lift saw by the two extension tables (F) as shown in Fig. 60.
REMOVING SAW FROM STAND
(FOR MODEL 36-250 ONLY)
B
A
C 
B
A
D
F
C
E
Fig. 61
If desired, your 10″ compound slide saw can be removed from the stand in order to use the saw on a workbench; on saw horses; or on 2 x 4 table extensions. To remove the saw from the stand, proceed as follows:
1.Pull out extension tables (A) Fig. 61, and lock in place.
2.Position extension arms (B) on two saw horses, as shown, or other suitable supports, making sure legs of stand are above floor surface.
3.Loosen two screws (C) Fig. 61, and remove screws (D) Fig. 61, as shown. Repeat these instructions for the rear of the stand.
4.Slide leg assembly (E) Fig. 61, off the saw base to the right and leg assembly (F) off the saw base to the left.
21