Delta 36-250, 36-240 Using the SAW on SAW Horses, Using SAW with 2 X 4 Extensions

USING THE SAW ON SAW HORSES

Figs. 69 and 70, illustrate the saw placed for use on saw horses. Notches in the front and rear of the mounting feet are designed to fit conveniently on saw horses. FOR MODEL 36-250 ONLY: Please note the table extensions and auxiliary fences (A) Fig. 70, can be used when operating the stand model on saw horses.

A

A

Fig. 69 Fig. 70

USING SAW WITH 2 X 4 EXTENSIONS

1.Fig. 71 illustrates the saw being used with 2 x 4 extensions. Note that notches in the front and rear of the mounting feet (K) are designed to fit and fastened to the top of the two 2 x 4’s (P). The length of the two 2 x 4’s (P) can vary depending on your preference. The distance from the top of the 2 x 4’s (P) to the saw table is 3-1/2″. This enables you to nail or fasten standard 2 x 4’s (R) to the 2 x 4’s (P), as shown. The top of the 2 x 4’s (R) will then be in alignment with the saw table, providing support for long work pieces. If desired, fence extensions (S) made of 2 x 2’s can be aligned with fence (T) and bolted to 2 x 4’s (R).

SS R R

R S R

P

P

Fig. 71

24