Delta 36-240, 36-250 Operating Controls and Adjustments, Starting Stopping Machine

Page 11

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND

STOPPING MACHINE

To start the machine, compress switch trigger (A) Fig. 28. To stop the machine, release the switch trigger.

This tool is equipped with an automatic electric blade brake. As soon as the switch trigger (A) Fig. 28 is released, the electric brake is activated and stops the blade in seconds.

DANGER: A TURNING SAW BLADE CAN BE DANGER-OUS. AFTER COMPLETING CUT, RELEASE SWITCH TRIGGER (A) FIG. 28, TO ACTIVATE BLADE BRAKE. KEEP CUTTINGHEAD DOWN UNTIL BLADE HAS COME TO A COMPLETE STOP.

WARNING: THE TORQUE DEVELOPED DURING BRAKING MAY LOOSEN THE ARBOR SCREW. THE A R B O R S C R E W S H O U L D B E C H E C K E D PERIODICALLY AND TIGHTENED IF NECESSARY.

LOCKING SWITCH IN

THE “OFF” POSITION

IMPORTANT: When the tool is not in use, the switch should be locked in the “OFF” position (to prevent unauthorized use) using a padlock (B), with a 3/16″ shank, as shown in Fig. 29. Padlock is available from Delta as an accessory.

A

Fig. 28

B

Fig. 29

ROTATING TABLE FOR MITER CUTTING

1.Your compound slide saw will cut any angle from a straight 90 degree cut to 57 degrees to the right and

47degrees to the left. Compress table locking lever (A) Fig. 30, and move the table to the desired angle. Then release table locking lever (A).

2.IMPORTANT: Table locking lever (A) Fig. 30, must be compressed when rotating the table. When locking lever (A) is not compressed, the table is in the locked position.

B A

Fig. 30

11

Image 11
Contents Sidekick Compound Slide Saw Always Wear EYE Protection Safety RulesAdditional Safety Rules for Compound Slide Saws Grounding Instructions Connecting Tool to Power SourcePower Connections Motor SpecificationsOperating Instructions Unpacking and CleaningExtension Cords Bench Model Stand Model AssemblyPage For models 36-240 Moving Cuttinghead to the Rear PositionAssembling Dust Elbow and Dust BAG Raising CuttingheadAssembling Work Clamp Moving Table to the 90 Degree CUT-OFF PositionRotating Table for Miter Cutting Operating Controls and AdjustmentsLocking Switch OFF Position Starting Stopping MachineAdjusting Clamping Action Table Locking Mechanism Table Hazard Area Adjusting Sliding FIT Between Movable Table and BaseAdjusting Fence Degrees to Blade Tilting Cuttinghead for Bevel Cutting Work Clamp OperationAdjusting Sliding FIT Between Trunnion and Bevel Bracket Adjusting 90 and 45 Degree Bevel Positive Stops Adjusting Sliding FIT Between Upper ARM and Trunnion Adjusting Blade GuardAdjusting Tension of Cuttinghead Return Spring Tool Storage Adjusting Downward Travel SAW BladeAdjusting Sliding FIT Between Guide Rods and Table Assembly Locking Cuttinghead Guide RodsUsing Auxiliary Fence AS a Stock Stop Adjusting Table Extensions Auxiliary FencesFolding Stand For Transportation Removing SAW from Stand Page For ALL Models Fastening the SAW to a WorkbenchUsing SAW with 2 X 4 Extensions Using the SAW on SAW HorsesReplacing SAW On Stand Correct Operating Procedure for Slide CuttingOperation Page Dado Cutting Using the Work Clamp and Stock StopUsing SAW AS Chop SAW Cutting Crown Moulding Changing the Blade MaintenanceBrush Inspection and Replacement PARTS, Service or Warranty Assistance AccessoriesPage Canadian PORTER-CABLE Delta Service Centers