Remove Saw From Stand (with tool mounts attached)
1.Press the unlock button on each tool mount and open the release lever to the unlocked position (see fig. 10, p8).
2.Locate the carry handles at the base of the saw. Place one hand on the saw base handle and the second on the saw’s top handle, as shown in figure 14. Holding tightly, tilt the saw (with the tool mounts still attached) toward yourself and lift it from the stand.
Attach the Saw to the Stand (with tool mounts attached)
1.Make sure the tool mount release levers on each mount are in the open and unlocked position (see fig. 10, p8).
2.Locate the carry handles at the base of the saw. Place one hand on the saw base handle and the second on the saw’s top handle. Lift the saw to the rail assembly.
3.Line up the left tool mount next to the red secondary stop on the rail assembly as close as possible.
4.Tilt the saw until the front jaws of both tool mounts are engaged to the rail. With both hands on the saw handles, guide the saw back to its level position on the rail (see fig. 7, p8).
5.Push the release lever on each tool mount to the locked position.
Be sure both tool mount ! WARNING levers are in the locked
position before operating or transporting the saw.
Expansion Rail Adjustment
1.Loosen the locking knob located along the side of the rail assembly, as shown in figure 15.
2.Extend expansion rail to desired length and retighten locking knob before beginning work.
3.Repeat process for opposite side.
FIG. 14
FIG. 15