Graco 16W866, ti23055a, 16W884, 16W881, 16W867, 16W887, 16W984, 16W873, 16W871, 16W882, 16W987 Cleanup

Page 19

Cleanup

1.Perform Pressure Relief Procedure (page 10), steps 1 - 4. Remove siphon tube set from paint and place in flushing fluid. Remove tip guard from gun.

ti14844a

NOTE: Use water for water-base paint, mineral spir- its for oil-base paint, or other solvents recom- mended by manufacturer.

2.Start Engine

a. Move fuel valve to open.

ti5248a

b. Move choke to closed.

ti5249a

c.Set throttle to fast.

ti5250a

d. Set engine switch to ON.

ti5262a

Cleanup

3. Pull rope to start engine.

ti5263a

4.Turn pump switch ON. Turn prime valve forward to SPRAY position.

OFF

ON

ti22729a

5.Increase pressure to 1/2. Hold gun against paint pail. Disengage trigger lock. Trigger gun until flush- ing fluid appears.

ti22730ati14846a

6.Move gun to waste pail, hold gun against pail, trig- ger gun to thoroughly flush system. Release trigger and engage trigger lock.

ti14847a

7.Turn prime valve down to DRAIN position and allow flushing fluid to circulate until flushing fluid appears clear.

8.Turn prime valve forward to SPRAY position. Trigger gun into flushing pail to purge fluid from hose.

ti14845a

ti14847a

332919C

19

Image 19

Contents Operation Table of Contents Fire and Explosion Hazard Equipment Misuse Hazard Standard Models 3400, 3900, 5900, 5900HD, 7900, 7900HD Component IdentificationProContractor Models 3900, 5900, 7900, 5900HD, 7900HD Ironman Models 5900, 7900, 7900HD Lo-Boy Models 3900, 5900 Convertible Models Pressure Relief Procedure Grounding Setup Change Engine to Motor Convertible Models OnlyStartup Spray Switch Tip Guard AssemblyWatchDog Protection System Clearing Tip ClogsProContractor and Ironman units only ProContractor units only Hose ReelJob Gallons Digital Tracking SystemProContractor and Ironman units Operation Main Menu Change Display UnitsPress and hold DTS button to clear error code to zero Cleanup Turn prime valve down Drain position Pressure Relief Procedure MaintenanceProblem Cause Solution TroubleshootingTroubleshooting Fluid Pump Runs Constantly Troubleshooting ProcedureControl Board Malfunction Volts Control Board Malfunction StepsConvertible Electric Motor Will Not Run Convertible Electric Motor Will Not Run Steps See step Is there over 10-20 AC volts? Beep Two blinks is the same as E=02 Digital Display MessagesPinion Assembly/Clutch Armature Removal Pinion Assembly/Clutch Armature/ClampInstallation Models Technical DataMetric Models Honda GX160 Engine Ansi Power Rating @ 3600 rpm Horsepower Honda GX200 Engine Ansi Power Rating @ 3600 rpm Horsepower Graco Information Graco Standard Warranty