Graco 16W887, ti23055a, 16W884, 16W881, 16W867, 16W984, 16W873, 16W871, 16W882 Equipment Misuse Hazard

Page 4

Warning

WARNING

EQUIPMENT MISUSE HAZARD

Misuse can cause death or serious injury.

Do not operate the unit when fatigued or under the influence of drugs or alcohol.

Do not exceed the maximum working pressure or temperature rating of the lowest rated system component. See Technical Data in all equipment manuals.

Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all equipment manuals. Read fluid and solvent manufacturer’s warnings. For complete information about your material, request MSDS from distributor or retailer.

Do not leave the work area while equipment is energized or under pressure.

Turn off all equipment and follow the Pressure Relief Procedure when equipment is not in use.

Check equipment daily. Repair or replace worn or damaged parts immediately with genuine manufacturer’s replacement parts only.

Do not alter or modify equipment. Alterations or modifications may void agency approvals and create safety hazards.

Make sure all equipment is rated and approved for the environment in which you are using it.

Use equipment only for its intended purpose. Call your distributor for information.

Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.

Do not kink or over bend hoses or use hoses to pull equipment.

Keep children and animals away from work area.

Comply with all applicable safety regulations.

PRESSURIZED ALUMINUM PARTS HAZARD

Use of fluids that are incompatible with aluminum in pressurized equipment can cause serious chemical reaction and equipment rupture. Failure to follow this warning can result in death, serious injury, or property damage.

Do not use 1,1,1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or fluids contain- ing such solvents.

Many other fluids may contain chemicals that can react with aluminum. Contact your material supplier for com- patibility.

CARBON MONOXIDE HAZARD

Exhaust contains poisonous carbon monoxide, which is colorless and odorless. Breathing carbon monoxide can cause death.

Do not operate in an enclosed area.

TOXIC FLUID OR FUMES HAZARD

Toxic fluids or fumes can cause serious injury or death if splashed in the eyes or on skin, inhaled, or swallowed.

Read MSDSs to know the specific hazards of the fluids you are using.

Store hazardous fluid in approved containers, and dispose of it according to applicable guidelines.

BURN HAZARD

Equipment surfaces and fluid that is heated can become very hot during operation. To avoid severe burns:

Do not touch hot fluid or equipment.

PERSONAL PROTECTIVE EQUIPMENT

Wear appropriate protective equipment when in the work area to help prevent serious injury, including eye injury, hearing loss, inhalation of toxic fumes, and burns. This protective equipment includes but is not limited to:

Protective eyewear, and hearing protection.

Respirators, protective clothing, and gloves as recommended by the fluid and solvent manufacturer.

RECOIL HAZARD

Gun may recoil when triggered. If you are not standing securely, you could fall and be seriously injured.

CALIFORNIA PROPOSITION 65

The engine exhaust from this product contains a chemical known to the State of California to cause cancer, birth defects or other reproductive harm.

This product contains a chemical known to the State of California to cause cancer, birth defects or other reproduc- tive harm. Wash hands after handling.

4

332919C

Image 4
Contents Operation Table of Contents Fire and Explosion Hazard Equipment Misuse Hazard Component Identification Standard Models 3400, 3900, 5900, 5900HD, 7900, 7900HDProContractor Models 3900, 5900, 7900, 5900HD, 7900HD Ironman Models 5900, 7900, 7900HD Lo-Boy Models 3900, 5900 Convertible Models Pressure Relief Procedure Grounding Setup Convertible Models Only Change Engine to MotorStartup Switch Tip Guard Assembly SprayWatchDog Protection System Clearing Tip ClogsProContractor and Ironman units only Hose Reel ProContractor units onlyDigital Tracking System ProContractor and Ironman units Operation Main MenuChange Display Units Job GallonsPress and hold DTS button to clear error code to zero Cleanup Turn prime valve down Drain position Maintenance Pressure Relief ProcedureTroubleshooting Problem Cause SolutionTroubleshooting Troubleshooting Procedure Fluid Pump Runs ConstantlyControl Board Malfunction Control Board Malfunction Steps VoltsConvertible Electric Motor Will Not Run Convertible Electric Motor Will Not Run Steps See step Is there over 10-20 AC volts? Beep Digital Display Messages Two blinks is the same as E=02Pinion Assembly/Clutch Armature/Clamp Pinion Assembly/Clutch Armature RemovalInstallation Models Technical DataMetric Models Honda GX160 Engine Ansi Power Rating @ 3600 rpm Horsepower Honda GX200 Engine Ansi Power Rating @ 3600 rpm Horsepower Graco Standard Warranty Graco Information