Cleanup
9.Raise siphon tube above flushing fluid and run sprayer for 15 to 30 seconds to drain fluid. Turn pump switch and engine OFF
12.If flushing with water, flush again with mineral spirits, or Pump Armor, to leave a protective coating to pre- vent freezing or corrosion.
13.Wipe sprayer, hose and gun with a rag soaked in water or mineral spirits.
ti22731a
10. Turn prime valve down DRAIN position. | ti2776a |
ti14842a
11.Remove filters from gun and sprayer, if installed. Clean and inspect. Install filters.
ti15018a
20 | 332919C |