Graco 16W885 Pinion Assembly/Clutch Armature/Clamp, Pinion Assembly/Clutch Armature Removal

Page 32

Pinion Assembly/Clutch Armature/Clamp

Pinion Assembly/Clutch Armature/Clamp

Pinion Assembly/Clutch Armature Removal

Pinion Assembly

If pinion assembly (29) is not removed from clutch hous- ing (19), do 1. through 3. Otherwise, start at 4.

1.Remove drive housing.

2.Disconnect clutch cable connectors from inside of pressure control.

a.Remove two screws (71) and swing down cover (130a).

b.Disconnect engine leads from board to engine.

c.Remove strain reliefs 130r and 123.

3.Remove four screws (36) and pinion assembly (29).

36

37

19

29

36

37

ti5480a

4.Place pinion assembly (29) on bench with rotor side up.

5.Remove four screws (28) and lock washers (24). Install two screws in threaded holes (E) in rotor. Alternately tighten screws until rotor comes off.

28 29

24

E E

6.Remove retaining ring (29b).

7.Turn pinion assembly over and tap pinion shaft (29a) out with plastic mallet.

27

29b

29a

29d

ti5482a

Clutch Armature

8.Use an impact wrench or wedge something between clutch armature (25) and clutch housing to hold engine shaft during removal.

9.Remove four screws (23) and lock washers (24).

10.Remove armature.







TIA

ti5481a

ti5987b

32

332919C

Image 32
Contents Operation Table of Contents Fire and Explosion Hazard Equipment Misuse Hazard Component Identification Standard Models 3400, 3900, 5900, 5900HD, 7900, 7900HDProContractor Models 3900, 5900, 7900, 5900HD, 7900HD Ironman Models 5900, 7900, 7900HD Lo-Boy Models 3900, 5900 Convertible Models Pressure Relief Procedure Grounding Setup Convertible Models Only Change Engine to MotorStartup Switch Tip Guard Assembly SprayProContractor and Ironman units only Clearing Tip ClogsWatchDog Protection System Hose Reel ProContractor units onlyDigital Tracking System ProContractor and Ironman units Operation Main MenuChange Display Units Job GallonsPress and hold DTS button to clear error code to zero Cleanup Turn prime valve down Drain position Maintenance Pressure Relief ProcedureTroubleshooting Problem Cause SolutionTroubleshooting Troubleshooting Procedure Fluid Pump Runs ConstantlyControl Board Malfunction Control Board Malfunction Steps VoltsConvertible Electric Motor Will Not Run Convertible Electric Motor Will Not Run Steps See step Is there over 10-20 AC volts? Beep Digital Display Messages Two blinks is the same as E=02Pinion Assembly/Clutch Armature/Clamp Pinion Assembly/Clutch Armature RemovalInstallation Metric Technical DataModels Models Honda GX160 Engine Ansi Power Rating @ 3600 rpm Horsepower Honda GX200 Engine Ansi Power Rating @ 3600 rpm Horsepower Graco Standard Warranty Graco Information