Graco ti15036b, ti14838b, ti15034a, ti15035b Check to see if transducer and control board

Page 14

Troubleshooting

TYPE OF PROBLEM	WHAT TO CHECK		HOW TO CHECK

Sprayer does not run at all	Check transducer or transducer	1.	Set sprayer to OFF and disconnect power to
	connections (control board is not		sprayer.
Digital display shows E=03	connections (control board is not		sprayer.
Digital display shows E=03	detecting a pressure signal).
	detecting a pressure signal).	2.	Check transducer and connections to control board.
		2.	Check transducer and connections to control board.
		3.	Disconnect transducer from control board socket.
			Check to see if transducer and control board
			contacts are clean and secure.
Control board status light blinks			contacts are clean and secure.
Control board status light blinks
3 times repeatedly		4.	Reconnect transducer to control board socket.
			Connect power, set sprayer ON and control knob
			to 1/2 turn clockwise. If sprayer does not run,
			set sprayer to OFF and go to next step.
		5.	Connect a confirmed working transducer to control
			board socket.
		6.	Set sprayer ON and control knob to 1/2 turn
			clockwise. If sprayer runs, install new transducer.
			Replace control board if sprayer does not run.
		7.	Check transducer resistance with ohmmeter (less
			than 9k ohm between red and black wires and 3-6k
			ohm between green and yellow wires).

14

3A0157B

Image 14

Contents Electric Airless Sprayers MarkModels Ultra MAX lIlTable of Contents Grounding Extension CordsFire and Explosion Hazard Skin Injection HazardPressurized Aluminum Parts Hazard Equipment Misuse HazardElectric Shock Hazard Moving Parts HazardComponent Identification Pressure Relief Procedure Extension Cord Power RequirementsGrounding PailsWhat to Check What to do Type of Problem TroubleshootingPerform Pressure Relief Procedure Mechanical/Fluid FlowFollow Pressure Relief Procedure on What to Check What to do Type of Problem Type of Problem What to Check HOW to Check ElectricalCheck to see if transducer and control board Step Check Motor Thermal Switch Unplug thermal Is not correct, replace motor Sprayer Will Not Shut Off YESSprayer Will Not Run Step Removal Installation VAC and 110 VAC Motor Control Board33 D 115 VAC Filter Board RemovalPressure Adjust Potentiometer Pressure Control Transducer Install control box 61 and control panel 68 with four screws 3A0157B Assembly Drive and Bearing Housing ReplacementDisassembly Drive and Bearing Housing Replacement Install Motor Shroud Motor ReplacementInstallation RemovalMotor Replacement Displacement Pump Replacement for 695/795/Mark Perform Relieve Pressure ProcedureTi7169a Displacement Pump Replacement 1095/1595/Mark Perform Pressure Relief Procedure,Place u-bolt on pump door protrusion Attach drain hose to sprayer Hose Reel Grease shaft Reed Switch Replacement RemovalInstallationON/OFF Wiring Diagram120V Models 120V Models with 15/20 Amp Switch 240V Models Thermal Switch Motor Leads SensorDip Switch AutoClean Watchdog Digital Display Potentiometer Pressure Transducer3A0157B Graco Standard Warranty Graco Information