Graco ti15036b, ti14838b, ti15034a, ti15035b important safety instructions 33 D 115

Page 22

Troubleshooting

5.Make switch dip switch is moved to the left (toward inside of board). See Wiring Diagram, page 40.

6.Connect motor connectors (F, G and H) and install into baffle.

7.Connect transducer connector (E) to motor control board.

8.Connect motor control board power connectors (K) to filter board (146).

9.Install control box (61) with top two screws (39).

10.Connect filter board power connectors (J) and power cord connectors (D) to ON/OFF switch (33).

11.Connect potentiometer connector (C) to motor con- trol board.

12.Connect WatchDog switch (X) and reed switch con- nector (L) to motor control board.

5

52

	146	61
	146	27
	A	C
		C
96
	J
38	33 D
39		E
		E
		80
68		82
		82
	82
	115
39	34

13.Install control panel (68) with two screws (39).

14.Connect display connector (A) to motor control board (52).

15.Install cover (96) with four screws (38)

16.Install Motor Shroud (for units equipped with Hose Reel only):

a.Loosen (but do not remove) four nuts on shelf and slide shelf forward.

b.Replace shroud.

c.Slide shelf back and tighten four nuts on shelf.

d.Replace bottom screw from toolbox and tighten.

e.Replace pressure tube from sprayer.

f.Replace bolts from motor shroud.

E 52

20

67

X

Fast Flush

1595 MARK V

ti14891a

22

3A0157B

Image 22

Contents Electric Airless Sprayers MarkModels Ultra MAX lIlTable of Contents Grounding Extension CordsFire and Explosion Hazard Skin Injection HazardPressurized Aluminum Parts Hazard Equipment Misuse HazardElectric Shock Hazard Moving Parts HazardComponent Identification Pressure Relief Procedure Extension Cord Power RequirementsGrounding PailsWhat to Check What to do Type of Problem TroubleshootingPerform Pressure Relief Procedure Mechanical/Fluid FlowFollow Pressure Relief Procedure on What to Check What to do Type of Problem Type of Problem What to Check HOW to Check ElectricalCheck to see if transducer and control board Step Check Motor Thermal Switch Unplug thermal Is not correct, replace motor Sprayer Will Not Shut Off YESSprayer Will Not Run Step Removal Installation VAC and 110 VAC Motor Control Board33 D 115 VAC Filter Board RemovalPressure Adjust Potentiometer Pressure Control Transducer Install control box 61 and control panel 68 with four screws 3A0157B Disassembly Drive and Bearing Housing ReplacementAssembly Drive and Bearing Housing Replacement Install Motor Shroud Motor ReplacementInstallation RemovalMotor Replacement Displacement Pump Replacement for 695/795/Mark Perform Relieve Pressure ProcedureTi7169a Displacement Pump Replacement 1095/1595/Mark Perform Pressure Relief Procedure,Place u-bolt on pump door protrusion Attach drain hose to sprayer Hose Reel Grease shaft Reed Switch Replacement RemovalInstallation120V Models Wiring DiagramON/OFF 120V Models with 15/20 Amp Switch 240V Models Thermal Switch Motor Leads SensorDip Switch AutoClean Watchdog Digital Display Potentiometer Pressure Transducer3A0157B Graco Standard Warranty Graco Information