Graco ti15036b, ti14838b, ti15034a, ti15035b important safety instructions Grease shaft

Page 38

Hose Reel

Installation

1. Grease shaft.

ti13537a

2.Make sure two washers and wave spring are on hub before hose reel is installed.

ti13545a

6.Install hose to swivel. Make sure to route hose through side arm of hose reel.

ti13539a

7.Turn hose reel clockwise to wrap up hose. Make sure hose is routed through hose guide.

3. Install hose reel onto frame. Place C-clamp on reel

 

and frame to allow snap ring to fit into place. Install

ti13504a

snap ring.

 

ti13536a

4. Install swivel.

ti13543a

5. Install E-clip and swivel cap.

ti13538a

38

3A0157B

Image 38
Contents Electric Airless Sprayers MarkModels Ultra MAX lIlTable of Contents Grounding Extension CordsFire and Explosion Hazard Skin Injection HazardPressurized Aluminum Parts Hazard Equipment Misuse HazardElectric Shock Hazard Moving Parts HazardComponent Identification Pressure Relief Procedure Extension Cord Power RequirementsGrounding PailsWhat to Check What to do Type of Problem TroubleshootingPerform Pressure Relief Procedure Mechanical/Fluid FlowFollow Pressure Relief Procedure on What to Check What to do Type of Problem Type of Problem What to Check HOW to Check ElectricalCheck to see if transducer and control board Step Check Motor Thermal Switch Unplug thermal Is not correct, replace motor Sprayer Will Not Shut Off YESSprayer Will Not Run Step Removal Installation VAC and 110 VAC Motor Control Board33 D 115 VAC Filter Board RemovalPressure Adjust Potentiometer Pressure Control Transducer Install control box 61 and control panel 68 with four screws 3A0157B Assembly Drive and Bearing Housing ReplacementDisassembly Drive and Bearing Housing Replacement Install Motor Shroud Motor ReplacementInstallation RemovalMotor Replacement Displacement Pump Replacement for 695/795/Mark Perform Relieve Pressure ProcedureTi7169a Displacement Pump Replacement 1095/1595/Mark Perform Pressure Relief Procedure,Place u-bolt on pump door protrusion Attach drain hose to sprayer Hose Reel Grease shaft Reed Switch Replacement RemovalInstallationON/OFF Wiring Diagram120V Models 120V Models with 15/20 Amp Switch 240V Models Thermal Switch Motor Leads SensorDip Switch AutoClean Watchdog Digital Display Potentiometer Pressure Transducer3A0157B Graco Standard Warranty Graco Information