Graco ti15035b, ti14838b, ti15034a, ti15036b Place u-bolt on pump door protrusion

Page 35

f.Place u-bolt on pump door protrusion.

ti6375a

8. Ratchet pump door forward.

ti6377a

9. Open pump door.

10. Pull out pump pin and place in pin holder.

ti7327a

Displacement Pump Replacement 1095/1595/Mark V

Installation

1.Adjust piston rod with pin holder to pull out piston rod. Tap piston rod on hard surface to push in piston rod.

2.Push pump collar flush with bearing housing ledge to be able to close pump door.

ti6325a

ti5492a

3.Slide pump into connecting rod. Push pump pin until it is fully retained.

NOTE: Pin will snap into position.

ti6378a

ti7328a

3A0157B

35

Image 35

Contents Mark Electric Airless SprayersUltra MAX lIl ModelsTable of Contents Extension Cords GroundingSkin Injection Hazard Fire and Explosion HazardMoving Parts Hazard Equipment Misuse HazardElectric Shock Hazard Pressurized Aluminum Parts HazardComponent Identification Pressure Relief Procedure Pails Power RequirementsGrounding Extension CordMechanical/Fluid Flow TroubleshootingPerform Pressure Relief Procedure What to Check What to do Type of ProblemFollow Pressure Relief Procedure on What to Check What to do Type of Problem Electrical Type of Problem What to Check HOW to CheckCheck to see if transducer and control board Step Check Motor Thermal Switch Unplug thermal Is not correct, replace motor YES Sprayer Will Not Shut OffSprayer Will Not Run Step VAC and 110 VAC Motor Control Board Removal Installation33 D 115 Removal VAC Filter BoardPressure Adjust Potentiometer Pressure Control Transducer Install control box 61 and control panel 68 with four screws 3A0157B Assembly Drive and Bearing Housing ReplacementDisassembly Drive and Bearing Housing Replacement Removal Motor ReplacementInstallation Install Motor ShroudMotor Replacement Perform Relieve Pressure Procedure Displacement Pump Replacement for 695/795/MarkTi7169a Perform Pressure Relief Procedure, Displacement Pump Replacement 1095/1595/MarkPlace u-bolt on pump door protrusion Attach drain hose to sprayer Hose Reel Grease shaft RemovalInstallation Reed Switch ReplacementON/OFF Wiring Diagram120V Models 120V Models with 15/20 Amp Switch Digital Display Potentiometer Pressure Transducer Thermal Switch Motor Leads SensorDip Switch AutoClean Watchdog 240V Models3A0157B Graco Information Graco Standard Warranty