Graco 16H241, 262612 important safety instructions Fine Finish Hand-Held Paint Sprayer 3A1698F

Page 1

Operation

Fine Finish Hand-Held Paint Sprayer		3A1698F
		EN
		EN

- For portable spray applications of architectural paints and coatings only -

- Not approved for use in explosive atmosphere locations -

- Service only at Graco approved service centers -

- For professional use only -

IMPORTANT SAFETY INSTRUCTIONS

Read all warnings and instructions in this manual. Save these instructions.

All Models:

Maximum Working Pressure 1700 psi (117 bar, 11.7 MPa)

Model





16F887		✓

16H240		✓

16H241				✓	✓

16H242				✓	✓

16H243				✓

262612				✓

16H245				✓

16H829				✓

ti16695a

Image 1

Contents Fine Finish Hand-Held Paint Sprayer 3A1698F Table of Contents Grounding Wire Repair Fire and Explosion Hazard Equipment Misuse Hazard Pressurized Aluminum Parts Hazard Component Identification Charger Status Indicator Lights Charging the BatterySprayer Status Indicator Prime/Pressure Relief Valve Position Trigger Lock Pressure Relief ProcedureSpray Tip Position Low Speed High Speed Setting Hi/Lo Switch Adjusting Pressure Motor SpeedFlexible Suction Tube SetupSpraying Ceilings, Walls and Crown Molding Spraying Floors and Base BoardsSprayer Setup Starting a New Job Or Refilling the Cup Reversible Tip Selection ChartGetting Started with Basic Techniques Install Tip/Guard Assembly if not installedTriggering Sprayer Aiming SprayerUnclogging Spray Tip/Guard Assembly Flushing Sprayer Shutdown and CleaningTi15529ati16727a Storage Cleaning Sprayer ExteriorFine Finish Tip Wear Replacement Parts and Kits Parts List Description 62-66 Model 16H240 16U241 Alternate Priming Method Installation Inlet Valve Removal/ServiceRemoval Outlet Valve RepairProblem Cause Solution TroubleshootingSee Reversible Tip Selection Chart Spray Pattern Diagnostics Problem Cause SolutionSpray pattern spits at Sprayer Technical DataPreferred Material Settings Log 3A1698F Graco Information Graco Standard Warranty