Cleaning Sprayer Exterior
•Wipe paint off outside of sprayer using a soft cloth moistened with water or flushing fluid.
Do NOT submerge the sprayer.
ti16728a
This sprayer is |
| |
equipped with a static |
| |
wick that reduces the |
| |
| ||
to reduce the risk of fire |
| |
and explosion. KEEP | ti16951a | |
THIS SURFACE | ||
|
Storage
1.Dilute 4 oz. bottle of Pump Armor Concentrate with an additional 4 oz. of water in material cup.
4 oz
ti16729a
2.Thread cup into sprayer, put prime/pressure relief valve to UP position and squeeze sprayer trigger for approximately 10 seconds.
ti16700a | ti16716a |
|
3.Reverse spray tip to UNCLOG position, put prime/pressure relief valve DOWN to spray position, and aim sprayer into waste area. Pull trigger for
CLEAN OF OVER- SPRAY.
ti14991ati16701a
ti16716a
Fine Finish Tip Wear
•Fine Finish Tip/Guard assembly may require replacement depending on abrasiveness of paint.
•Do not spray with worn tip. See Troubleshooting, page 26.
Storage
NOTICE
Failure to store sprayer with Pump Armor will result in operational problems the next time you spray. Always circulate Pump Armor through the sprayer after clean- ing. Water or solvents other than mineral spirits left in the sprayer will corrode and damage the pump.
4.Properly dispose of used Pump Armor mixture from material cup and rinse cup with water.
ti16726a
5.Recharge battery to full charge before storage. See Charging the Battery, page 8.
6.Store sprayer indoors in a cool, dry place. Store in an upright position only. Never store sprayer with material in the cup.
ti16730a
18 | 3A1698F |