Alcatel Carrier Internetworking Solutions user manual ACT 250 remote connector wiring

Page 14

Commissioning

ACT 250 remote connector wiring

Use in local mode ■ Standard connector plug (factory wired)

6

111 12

10

5 15

Wiring seen from solder side

Use in remote control mode

■With galvanic isolation (recommended)

Wiring seen from solder side.

	compulsory screen	customer
	6	device
	6	15 V –> 24 V
1	11	15 V –> 24 V
	12
	13
	14
	10
5	15
5
	ACT unit
	ground

➞Ext. safety

➞Select. Mode

➞Standby Mode

➞Start/Stop

➞Common for inputs

device ground

■ Without galvanic isolation (not recommended)

Wiring seen from solder side.

2001

6

111 12 13

compulsory screen	customer
	device

➞ Ext. safety

➞ Select. Mode

➞ Standby Mode

January

10

14

➞ Start/Stop

5

15

ACT unit ground

device ground

The voltage used to power the contacts is supplied by the ACT 250 (terminal 5). The disadvantage of this method is the risk of exposing this voltage to external interference (see also diagrams on page 11 ).

Alcatel Vacuum Technology France - ACT 250 addendum

13

Image 14

Contents ACT Contents Syntax conventions applicable to all commands UsePresentation ACT 250 controllerEurope 108936 108948 Accessories108935 There are three possible remote control modes Local control modeRemote control ACT 250 box controller control modesACT 250 OEM controller control modes ACT 250 controller technical characteristics ACT 250 box dimensions in mmACT 250 OEM dimensions in mm Safety instructions CommissioningACT 250 controller electrical connections Ext. safety Select Mode ACT 250 remote connector characteristicsVoltage control mode Principle of voltage- controlled optocoupled inputsSignalling on output contacts ACT 250 remote connector wiring Use in remote control modeParity Wiring the RS 232 or RS 485 serial linkRS 232 / 485 serial link Baud rate 9600 4800Result #aaa,ok or Err2 Detailed description of RS commandsSyntax conventions applicable to all commands #adrCKSOFFCRLF Result #adr,ok,S For CksonEnables DataLogger operation RS232 only Result #adr,ok or Err2Identiﬁes the device which is communicating, and its IDN#adrECHOFFCRLF Software versionNSP LEVLNG Syntax ResultSAV OPTRPM Syntax Result See also SELDeﬁnes the character which separates the parameters Result #adr,ok or #adr,ErrX If errorSEL A reply Syntax #adrSEPnnnCRLFSPD SETSHT Syntax Result See also LEVTMP Deﬁnes the turbomolecular pump operating stateUse Controlling the pump from the ACT 250 controllerStarting the pump with the Start switch Indication of rotation during operation controller on Precautions Local mode operationController functions Use Italy FranceGermany Japan