Grizzly G9969 owner manual Test Run, To test run your machine

Page 21

Test Run

Wear safety glasses whenever starting or using machine. Failure to comply may result in serious personal injury.

Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.

Once the assembly is complete, test run your machine to make sure it runs properly, and to test prominent safety features installed on the machine.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review the Troubleshooting on Page 29.

If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

G9969 Radial Drill Press

To test run your machine:

1.Ensure that anyone in the vicinity of the drill press, including yourself, is wearing safety glasses.

2.Make sure you have read the safety instruc- tions at the beginning of the manual and that the machine is set up properly.

3.Make sure all tools and objects used during setup are cleared away from the machine.

4.Connect the machine to the power source.

5.Remove the safety switch key (on Page 20) from the main switch.

6.Move the switch to the ON position. The drill press should NOT switch on.

7.Move the switch to the OFF position and insert the safety switch key into the switch.

8.Turn the drill press ON.

9.Listen to and watch for abnormal noises or actions. The machine should run smoothly with little or no vibration or rubbing noises.

10.Turn the drill press OFF.

11.Strange or unusual noises should be inves- tigated and corrected before operating the machine further. ALWAYS disconnect the machine from power when investigating or correcting potential problems.

-19-

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Model G9969 Radial Drill Press Page Table of Contents Introduction ForewordContact Info Identification Machine Data Sheet 39-1/2 Safety G9969 Radial Drill Press Safety for Drill Presses 110/220V Operation Circuit RequirementsAmperage Draw Circuit RequirementsExtension Cords Grounding110V Operation 220V OperationSet Up Safety SET UPItems Needed for Set Up UnpackingInventory Clean UpBox 1 Figure Qty Other Components and Hardware QtyHardware Recognition Chart Mounting Site ConsiderationsColumn To install the column on the baseHeadstock Bracket Components and Hardware Needed QtyHeadstock To install the headstockTo install the downfeed handles To install a light bulb in the drill pressDownfeed Handles Belt Cover Knob To assemble the drill chuck and mount it to the spindle Drill Chuck & ArborTo test run your machine Test RunTo install a drill bit Operation Safety Safety Switch KeyOperations Changing BitsArbor Removal To remove a drill bitTo remove the drill chuck and arbor Basic Drilling Operations Using the Drill Bit Speed Chart Choosing SpeedsLubrication Suggestions To change speeds Changing SpeedsDepth Stop To set the depth stopTo set the spindle return distance Headstock Height & Column Rotation Headstock AdjustmentHeadstock Tilt Headstock SwivelAccessories G5753-Drill Press ViseH1300 H1298 G7984 H2347 H0736 Maintenance About Service ServiceTroubleshooting Symptom Possible Cause Possible SolutionDrill Press Operations To calibrate the depth stop Depth Stop Feed Shaft Spring CalibrationLoosening cover and jam nut Electrical Components G9969 Switch WiringWiring Diagram Parts Breakdown Description Parts ListParts List and Label Placement Warranty and Returns Page Page
Top Page Image Contents