Grizzly G9969 owner manual Column, Headstock Bracket, Components and Hardware Needed Qty

Page 17

Lag Shield Anchor

Lag Bolt

Typical Anchor Stud

Machine Mount

Figure 5. Different floor mounting methods.

Column

Components and Hardware Needed:			Qty
Base			1
Column			1
Hex Bolts 1⁄	"-13 x 2"		4
2		"	4
Flat Washers 1⁄
	2

To install the column on the base:

1.Place the column on the base, making sure to align the holes in both the column and the base.

2.Have an assistant hold the column steady- while you secure the column to the base with the hex bolts, as shown in Figure 6.

G9969 Radial Drill Press

Figure 6. Assembled column and base.

Headstock Bracket

Components and Hardware Needed:	Qty
Headstock Bracket	1
Column	1
Column Cap	1
Lock Handles	2
Crank Handle	1
Crank Handle Arm	1

To mount the headstock bracket on the col- umn:

1.Mark the top of the rack, as shown in Figure 7, to reference which end is the top.

Figure 7. Marking the top of the rack.

2.Loosen the cap screw on the column cap and remove the cap and rack from the column.

-15-

Image 17

Contents Model G9969 Radial Drill Press Page Table of Contents Contact Info IntroductionForeword Identification Machine Data Sheet 39-1/2 Safety G9969 Radial Drill Press Safety for Drill Presses 110/220V Operation Circuit RequirementsAmperage Draw Circuit RequirementsExtension Cords Grounding110V Operation 220V OperationSet Up Safety SET UPItems Needed for Set Up UnpackingInventory Clean UpBox 1 Figure Qty Other Components and Hardware QtyHardware Recognition Chart Mounting Site ConsiderationsColumn To install the column on the baseHeadstock Bracket Components and Hardware Needed QtyHeadstock To install the headstockDownfeed Handles Belt Cover Knob To install the downfeed handlesTo install a light bulb in the drill press To assemble the drill chuck and mount it to the spindle Drill Chuck & ArborTo test run your machine Test RunTo install a drill bit Operation Safety Safety Switch KeyOperations Changing BitsTo remove the drill chuck and arbor Arbor RemovalTo remove a drill bit Basic Drilling Operations Lubrication Suggestions Using the Drill Bit Speed ChartChoosing Speeds To change speeds Changing SpeedsTo set the spindle return distance Depth StopTo set the depth stop Headstock Height & Column Rotation Headstock AdjustmentHeadstock Tilt Headstock SwivelH1300 H1298 G7984 H2347 H0736 AccessoriesG5753-Drill Press Vise Maintenance About Service ServiceTroubleshooting Symptom Possible Cause Possible SolutionDrill Press Operations To calibrate the depth stop Depth Stop Feed Shaft Spring CalibrationLoosening cover and jam nut Electrical Components G9969 Switch WiringWiring Diagram Parts Breakdown Description Parts ListParts List and Label Placement Warranty and Returns Page Page