Grizzly G9969 owner manual Operations, Operation Safety Safety Switch Key, Changing Bits

Page 22

SECTION 4: OPERATIONS

Operation Safety		Safety Switch Key

Wear safety glasses when operating this machine. Serious injury may occur if this warning is ignored!

Loose hair and cloth-

ing could get caught in

machinery and cause seri-

ous personal injury. Keep

loose clothing and long

hair away from moving machinery.

NOTICE

If you have never used this type of machine or equipment before, WE STRONGLY REC- OMMEND that you read books, trade maga- zines, or get formal training before begin- ning any projects. Regardless of the con- tent in this section, Grizzly Industrial will not be held liable for accidents caused by lack of training.

To prevent the machine from starting, remove the safety switch key (Figure 17) from the paddle switch.

Figure 17. Removing key to disable switch.

Changing Bits

The Model G9969 is equipped with a key chuck, which can be opened and securely closed by using the included chuck key. Any drill bit you install in the chuck must be installed tightly enough that it will not come loose during opera- tion.

To install a drill bit:

1.UNPLUG THE DRILL PRESS!

2.Open the drill chuck wide enough to accept the shank of the drill bit.

3.Insert the drill bit as far as possible into the chuck WITHOUT allowing the chuck jaws to touch the fluted portion of the bit, and hand tighten the chuck.

-20-	G9969 Radial Drill Press

Image 22

Contents Model G9969 Radial Drill Press Page Table of Contents Foreword IntroductionContact Info Identification Machine Data Sheet 39-1/2 Safety G9969 Radial Drill Press Safety for Drill Presses Amperage Draw Circuit Requirements110/220V Operation Circuit Requirements110V Operation GroundingExtension Cords 220V OperationItems Needed for Set Up SET UPSet Up Safety UnpackingBox 1 Figure Qty Clean UpInventory Other Components and Hardware QtyHardware Recognition Chart Site Considerations MountingHeadstock Bracket To install the column on the baseColumn Components and Hardware Needed QtyTo install the headstock HeadstockTo install a light bulb in the drill press To install the downfeed handlesDownfeed Handles Belt Cover Knob Drill Chuck & Arbor To assemble the drill chuck and mount it to the spindleTest Run To test run your machineOperations Operation Safety Safety Switch KeyTo install a drill bit Changing BitsTo remove a drill bit Arbor RemovalTo remove the drill chuck and arbor Basic Drilling Operations Choosing Speeds Using the Drill Bit Speed ChartLubrication Suggestions Changing Speeds To change speedsTo set the depth stop Depth StopTo set the spindle return distance Headstock Tilt Headstock AdjustmentHeadstock Height & Column Rotation Headstock SwivelG5753-Drill Press Vise AccessoriesH1300 H1298 G7984 H2347 H0736 Maintenance Troubleshooting ServiceAbout Service Symptom Possible Cause Possible SolutionDrill Press Operations Depth Stop Feed Shaft Spring Calibration To calibrate the depth stopLoosening cover and jam nut G9969 Switch Wiring Electrical ComponentsWiring Diagram Parts Breakdown Parts List DescriptionParts List and Label Placement Warranty and Returns Page Page