Grizzly G9969 owner manual Maintenance

Page 30

SECTION 6: MAINTENANCE

Always disconnect power to the machine before performing maintenance. Failure to do this may result in serious person- al injury.

General

Regular periodic maintenance on your drill press will ensure optimum performance. Make a habit of inspecting your machine each time you use it. Check for the following conditions and repair or replace when necessary:

Loose mounting bolts.

Worn switch.

Worn or damaged cords and plugs.

Worn or damaged V-belts.

Loose chuck or arbor.

Any other condition that could hamper the safe operation of this machine.

Cleaning

Cleaning the Model G9969 is relatively easy. Vacuum excess wood chips and sawdust, and wipe off the remaining dust with a dry cloth. If any resin has built up, use a resin dissolving cleaner to remove it. Treat all unpainted cast iron and steel with a non-staining lubricant after cleaning.

-28-

Unpainted Cast Iron

Protect the unpainted cast iron surfaces by wip- ing them clean after every use—this ensures moisture from wood dust does not remain on bare metal surfaces.

Keep these surfaces rust-free with regular appli- cations of products like G96® Gun Treatment, SLIPIT®, or Boeshield® T-9. These are available in the latest Grizzly catalog under the model num- bers shown below:

G96® Gun Treatment

H3788

SLIPIT® Compound Gel

G5562

Boeshield® T-9

H7373

Lubrication

Since all bearings are shielded and permanently lubricated, simply leave them alone until they need to be replaced. DO NOT lubricate them.

Keep quill, spindle, column, and table top well lubricated to prevent rust.

V-Belts

Inspect regularly for tension and wear. Check pulleys to ensure that they are properly aligned. See Changing Speeds on Page 23 for more information about removing/installing belts if you need help replacing the belts.

G9969 Radial Drill Press

Image 30
Contents Model G9969 Radial Drill Press Page Table of Contents Introduction ForewordContact Info Identification Machine Data Sheet 39-1/2 Safety G9969 Radial Drill Press Safety for Drill Presses Amperage Draw Circuit Requirements110/220V Operation Circuit Requirements110V Operation GroundingExtension Cords 220V OperationItems Needed for Set Up SET UPSet Up Safety UnpackingBox 1 Figure Qty Clean UpInventory Other Components and Hardware QtyHardware Recognition Chart Site Considerations MountingHeadstock Bracket To install the column on the baseColumn Components and Hardware Needed QtyTo install the headstock HeadstockTo install the downfeed handles To install a light bulb in the drill pressDownfeed Handles Belt Cover Knob Drill Chuck & Arbor To assemble the drill chuck and mount it to the spindleTest Run To test run your machineOperations Operation Safety Safety Switch KeyTo install a drill bit Changing BitsArbor Removal To remove a drill bitTo remove the drill chuck and arbor Basic Drilling Operations Using the Drill Bit Speed Chart Choosing SpeedsLubrication Suggestions Changing Speeds To change speedsDepth Stop To set the depth stopTo set the spindle return distance Headstock Tilt Headstock AdjustmentHeadstock Height & Column Rotation Headstock SwivelAccessories G5753-Drill Press ViseH1300 H1298 G7984 H2347 H0736 Maintenance Troubleshooting ServiceAbout Service Symptom Possible Cause Possible SolutionDrill Press Operations Depth Stop Feed Shaft Spring Calibration To calibrate the depth stopLoosening cover and jam nut G9969 Switch Wiring Electrical ComponentsWiring Diagram Parts Breakdown Parts List DescriptionParts List and Label Placement Warranty and Returns Page Page