Bosch Power Tools 38636 Removing Chuck, Installing Chuck, Battery Charged Condition Indicator

BM 2610944822 11-06 12/1/06 4:05 PM Page 10

REMOVING CHUCK

Rotate the clutch ring to the drill bit

symbol “ ”. Open the chuck all the way, remove left-hand thread screw inside chuck by turning it clockwise (Fig. 2).

Insert the short arm of a 1/2" hex key wrench and close jaws on flats of wrench (Fig. 3). Strike long arm of wrench sharply counterclockwise, remove wrench and unthread chuck from spindle.

INSTALLING CHUCK

Always keep the spindle threads, the threads of the chuck and securing screw free of

debris. To install a chuck, reverse “removing the chuck” procedure.

FIG. 3

FIG. 4

AUXILIARY HANDLE

The tool must be supported with the auxiliary handle, which can be swiveled 360˚. To reposition and/or swivel the handle, loosen the hand grip, move the handle to the desired position along the barrel and securely retighten the hand grip (Fig. 4).

BATTERY CHARGED CONDITION

INDICATOR

The battery is equipped with a charged condition indicator.

GREEN

INDICATOR LIGHTS

	RED
BUTTON
	INDICATOR LIGHT

By pressing the button ON, the charged condition can be checked when the battery is

removed or when the machine is not in use. After approx. 5 seconds, the charged indicator switches off automatically.

•• • When all three lights are illuminated, this indicates the battery pack is between 67% and 100% charged.

•• When only two lights illuminate, this indicates the battery pack is between 33% and 66% charged.

•When only one light illuminates, this indicates the battery pack is less than 33% charged.

When one light blinks the battery pack is almost fully discharged.

-10-